AN2811

Safety instructions

Doc ID 14904 Rev 1

5/25

1

Safety instructions

Warning:

The demonstration board must be used in a suitable

laboratory by only qualified personnel who are familiar with

the installation, use, and maintenance of electrical systems.

Intended use

The demonstration board is a component designed for demonstration purposes only, and

shall be used neither for domestic installation nor for industrial installation. The technical

data as well as the information concerning the power supply and working conditions shall be

taken from the documentation included with the demonstration board and strictly observed.

Installation

The installation of the demonstration board shall be taken from the present document and

strictly observed. The components must be protected against excessive strain. In particular,

no components are to be bent, or isolating distances altered during the transportation,

handling or usage. The demonstration board contains electro-statically sensitive

components that are prone to damage through improper use. Electrical components must

not be mechanically damaged or destroyed (to avoid potential risks and health injury).

Electrical connection

Applicable national accident prevention rules must be followed when working on the mains

power supply. The electrical installation shall be completed in accordance with the

appropriate requirements (e.g. cross-sectional areas of conductors, fusing, and PE

connections).

Board operation

A system architecture which supplies power to the demonstration board shall be equipped

with additional control and protective devices in accordance with the applicable safety

requirements (e.g. compliance with technical equipment and accident prevention rules).