Model. No.

Rev.

■

■

■

■ Precautions for use:

Page

The shelf life of LEDs stored in the original sealed bag at <40

℃ and < 90% RH is 12 months. Baking is

FYLS-0603ASGC

frequently during the baking process.

2. Soldering

(1) Manual soldering with a soldering Iron

Http://www.foryard.com

Before opening the packaging , check for air leaks in the bag.

baking is required Take the material out of the packaging bag before baking. Do not open the oven door

Use a soldering iron of less than 25 watts is recommended . The iron temperature must be kept below 315

℃

Handling of an SMD LED should be done only when the package has been cooled down to below 40

℃

The epoxy resin of an SMD LED should not contact the tip of the soldering iron.

No mechanical stress should be exerted on the resin portion of an SMD LED during soldering.

SMD LEDs must be used within 24 hours. If the LEDs are not within 24 hours after removal from the bag ,

After the bag is opened, the SMD LEDs must be stored at <30

℃ and < 60% RH. Under these conditions,

Model No.

：

：

：

：FYLS-0603ASGC

required if the shelf life has expired

secondary protection

A

To prevent moisture absorption into SMD LEDs during the transportation and storage , the LEDs are packed

in a moisture-barrier bag. Desiccants and a humidity indicator are packed together with the LEDs as

1. Storage

(2)Reflow soldering

Temperature profile

And soldering time no more than 2 seconds.

Peak temperature

Temperature

Pre-heat

Soak

Reflow

Cooling

Time

Melting-point