4

Functional Pin Description

VSEN (Pin 1)

This pin is connected to the converters output voltage. The

PGOOD and OVP comparator circuits use this signal to

report output voltage status and for overvoltage protection.

OCSET (Pin 2)

the converter over-current (OC) trip point according to the

following equation:

An over-current trip cycles the soft-start function.

SS (Pin 3)

Connect a capacitor from this pin to ground. This capacitor,

along with an internal 10

µA current source, sets the soft-

start interval of the converter.

VID0-3 (Pins 4-7)

VID0-3 are the input pins to the 4-bit DAC. The states of

these four pins program the internal voltage reference

(DACOUT). The level of DACOUT sets the converter output

voltage. It also sets the PGOOD and OVP thresholds. Table

1 specifies DACOUT for the 16 combinations of DAC inputs.

EN (Pin 8)

This pin is the open-collector enable pin. Pull this pin below

1V to disable the converter. In shutdown, the soft start pin is

discharged and the UGATE pin is held low.

COMP (Pin 9) and FB (Pin 10)

COMP and FB are the available external pins of the error

amplifier. The FB pin is the inverting input of the error

amplifier and the COMP pin is the error amplifier output.

These pins are used to compensate the voltage-control

feedback loop of the converter.

GND (Pin 11)

Signal ground for the IC. All voltage levels are measured with

respect to this pin.

PGOOD (Pin 12)

PGOOD is an open collector output used to indicate the

status of the converter output voltage. This pin is pulled low

when the converter output is not within

±10% of the

DACOUT reference voltage.

PHASE (Pin 13)

Connect the PHASE pin to the upper MOSFET source. This

input pin is used to monitor the voltage drop across the

MOSFET for over-current protection. This pin also provide

the return path for the upper gate drive.

UGATE (Pin 14)

Connect UGATE to the upper MOSFET gate. This pin

provides the gate drive for the upper MOSFET.

Typical Performance Curves

FIGURE 2. BIAS SUPPLY CURRENT vs FREQUENCY

10

100

1000

SWITCHING FREQUENCY (kHz)

10

100

1000

TO +12V

100

200

300

400

500

600

700

800

900

1000

80

70

60

50

40

30

20

10

0

SWITCHING FREQUENCY (kHz)

11

12

13

14

15

16

17

18

20

19

10

9

8

7

6

5

4

3

2

1

VSEN

OCSET

SS

VID0

VID1

VID2

EN

VID3

COMP

FB

RT

VCC

LGATE

PGND

OVP

BOOT

UGATE

PHASE

PGOOD

GND

I

PEAK

I

OCS

R

OCSET

•

r

DS ON

()

--------------------------------------------

=

HIP6002