Polyphase Energy Metering IC

with Phase Drop Indication

ADE7762

Rev. 0

Information furnished by Analog Devices is believed to be accurate and reliable. However, no

responsibilityis assumedbyAnalogDevicesforitsuse,norforanyinfringementsof patentsorother

rightsofthirdpartiesthatmayresultfromitsuse.Specificationssubjecttochangewithoutnotice.No

license is granted by implication or otherwise under any patent or patent rights of Analog Devices.

Trademarksandregisteredtrademarksarethepropertyoftheirrespectiveowners.

One Technology Way, P.O. Box 9106, Norwood, MA 02062-9106, U.S.A.

Tel: 781.329.4700

www.analog.com

Fax: 781.461.3113

©2007 Analog Devices, Inc. All rights reserved.

FEATURES

High accuracy supports 50 Hz/60 Hz IEC 62053-21

Less than 0.1% error over a dynamic range of 500 to 1

Compatible with 3-phase, 3-wire delta and 3-phase, 4-wire

Wye configurations

Supplies average active power on the frequency outputs F1

and F2

High frequency output (CF) is intended for calibration and

supplies instantaneous active power

Logic output REVP indicates a potential miswiring or

negative power on the sum of all phases

Dropout indication for each phase on LED driver pins

Phase sequence error detection

Direct drive for electromechanical counters and 2-phase

stepper motors (F1 and F2)

Proprietary ADCs and DSP provide high accuracy over large

variations in environmental conditions and over time

On-chip power supply monitoring

On-chip creep protection (no load threshold)

On-chip reference 2.4 V ± 8% (25 ppm/°C typical) with

external overdrive capability

Single 5 V supply, low power (42.5 mW typical)

Low cost CMOS process

GENERAL DESCRIPTION

The ADE7762 is a high accuracy polyphase electrical energy

measurement IC. The ADE7762 specifications surpass the

accuracy requirements as quoted in the IEC62053-21 standard.

The only analog circuitry used in the ADE7762 is in the

analog-to-digital converters (ADCs) and reference circuit. All

other signal processing (for example, multiplication, filtering,

and summation) is carried out in the digital domain. This

approach provides superior stability and accuracy over

extremes in environmental conditions and over time.

The ADE7762 supplies average active power information on

the low frequency outputs, F1 and F2. These logic outputs can

be used to directly drive an electromechanical counter or to

interface with a microcontroller (MCU). The CF logic output

gives instantaneous active power information. This output is

intended to be used for calibration purposes.

The ADE7762 includes a power supply monitoring circuit on the

resets and no pulses are issued on F1, F2, and CF.

A multiple multiplexed logic output provides phase dropout per

phase, reverse polarity per phase, and a phase sequence error.

Internal phase matching circuitry ensures that the voltage and

current channels are phase matched. An internal no load

threshold ensures that the ADE7762 does not exhibit any creep

when there is no load.

The ADE7762 is available in a 28-lead SOIC package.