GS3441 Extended Reach 3G/HD/SD Adaptive Cable

Equalizer with Dual Outputs

Final Data Sheet

Rev. 1

GENDOC-056647

May 2013

15 of 25

Proprietary & Confidential

www.semtech.com

4.4 Programmable Squelch Adjust (SQ_ADJ)

The GS3441 features a programmable Squelch Adjust (SQ_ADJ) threshold.

This feature can be useful in applications where there are multiple input channels using

the GS3441 and the maximum gain can be limited to avoid crosstalk.

The SQ_ADJ pin acts to change the threshold of the Carrier Detect (CD) pin, through

voltage level variances. When the input signal drops below a certain threshold set by

SQ_ADJ, the CD pin will be driven HIGH, indicating that there is not a valid input signal.

In applications where programmable squelch adjust is not required, the SQ_ADJ pin can

be left unconnected.

This feature has been designed for use in applications such as routers, where signal

crosstalk and circuit noise cause the equalizer to output erroneous data when no input

signal is present. The use of a Carrier Detect function with a fixed internal reference

does not solve this problem, since the signal-to-noise ratio on the circuit board could be

significantly less than the default signal detection level set by the on-chip reference.

Note:

When using SQ_ADJ to limit the maximum gain of the GS3441, CD should not be

connected to SLEEP.

4.5 Carrier Detect, Sleep, and Auto-Sleep

The Carrier Detect output pin (CD) indicates the presence of a valid signal at the input of

the GS3441. When CD is LOW, the device has detected a valid input on SDI and SDI.

When CD is HIGH, the device has not detected a valid input.

The GS3441 includes a SLEEP input pin, which can be used to put the device into a

low-power sleep mode, consuming less than 35mW. In this mode, the outputs are high

impedance and will be pulled high by the on-chip termination. Set the SLEEP pin HIGH

to place the chip in this low-power state. In this mode, the Carrier Detect output will still

function to facilitate the detection of a valid serial input data signal.

Auto-Sleep is enabled by connecting CD to SLEEP. When connected, the GS3441 will

automatically go into low-power sleep mode when there is a loss of Serial Digital Input

signal.

Note 1:

CD will only detect loss of carrier for data rates greater than 19Mb/s.

Note 2:

If SQ_ADJ is being used to limit the maximum gain of the device, and the

maximum cable length is exceeded when BYPASS pin is set LOW, the CD pin will be set

HIGH even if a carrier is present.

Note 3:

If the CD pin is connected to the SLEEP pin, SQ_ADJ must be either left open, or

connected to ground.

Table 4-2: SLEEP Input Table

SLEEP

Function

0The GS3441 operates normally

1

The GS3441 enters low-power sleep

mode. CD output remains valid