P2CF-08 datasheet(17/23 Pages) OMRON

17 / 23 page

E2C/E2C-H

E2C-A

@4A

Using P2CF-11, P2CF-08

When aligning the Amplifier Unit vertically with the Socket, consider

the space required for the hooks and allow a leeway of about 20 mm

above and below the Amplifier Unit.

Mounting Embedded in a Panel

(1)When using the Y92F-30 Embedded Mounting Adapter, insert the

Amplifier Unit into a square hold in the panel, attach the Adapter

from the back and press in to reduce the gap with the panel. Then

secure the Adapter with the screws.

(2)When using the Y92F-70 or Y92F-71 Embedded Mounting

Adapter, just press the Amplifier into a square hole in the panel. If

the panel coating is too thick and the hooks do not lock in place,

spread the hooks from the back by pushing in the directions of the

arrows.

Removing the Amplifier Unit

• When the Amplifier Unit is mounted using the Y92F-30, loosen the

screws on the adapter, spread the hooks at the top and bottom, and

remove the Adapter.

• Using Y92F-70, Y92F-71

Press in on the hooks with your thumb and forefinger and press

forward on the Amplifier Unit.

● Wiring

Self-diagnostic Output

When not using the self-diagnostic output, connect the orange wire to

0 V or cut it and wrap it with insulation tape so that it does not come

into contact with other terminals.

● Miscellaneous

The sensor does not have a water-resistant structure. Do not use it

where it would be subjected to water or water vapor.

P2CF-11

P2CF-08

Hook

Duct or

other object

Panel

Y92F-30

Panel

Insert the Amplifier Unit and

then spread the hooks.

Insert the Sensor and then

spread the hooks.

Panel

Hook

P2CF-08 датащи(PDF) 17 Page - Omron Electronics LLC

P2CF-08 датащи(HTML) 17 Page - Omron Electronics LLC

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23

датащи скачать

ссылки URL