OPTEK Technology Inc. —

1645 Wallace Drive, Carrollton, Texas 75006

Phone: (972) 323-2200 or (800) 341-4747

FAX: (972) 323-2396 sensors@optekinc.com www.optekinc.com

Issue C.1 1/10

Page 1 of 6

Photologic

OPB960, OPB970, OPB980, OPB990 Series

OPTEK reserves the right to make any changes at any time in order to improve design and to supply the best product possible.

Features:

Description:

specific requirements for the design engineer.

Building from a standard housing with a 0.125” (3.18mm) wide slot, the user can specify output logic state, output driver circuit,

aperture width, aperture surface and mounting tab locations. Furthermore, an option of wire or PCB leads allows electrical

interface flexibility.

The device body is an opaque plastic which minimizes sensitivity to both visible and near-infrared external light sources which

may impact operation. Aperture width choices provide different optical resolution for motion sensing. A covered aperture

provides dust protection, while an open aperture provides maximum protection against external light sources.

Electrical operation is over a wide supply voltage range. LED emissions are near-infrared (850—940nm).

Detector digital output logic choices of buffer or inverter with totem-pole or open-collector driver circuit simplify interface for

various electrical requirements.

Custom electrical, wire and cabling services are available.

Contact your local representative or OPTEK for more information. Compliant to EU RoHS Directive 2002/95/EC .

RoHS

OPTEK Assembly

Photologic

®

Sensor Family

Slot Aperture Surface and Lead Options:

6 —

Covered (apertures not visible), PCB leads

7 —

Open (apertures visible), PCB leads

8 —

Covered (apertures not visible), Wires

9 —

Open (apertures visible), Wires

Logic and Output Driver Types:

0 —

Buffer Totem-Pole

1 —

Buffer Open-Collector

2 —

Inverter Totem-Pole

3 —

Inverter Open-Collector

Z =

Wires only, None for PCB leads

Aperture Width Guide Options:

55, 51, 11 ( See Aperture Width Guide )

Mounting Tab Location:

L —

Emitter

N —

None

P —

Sensor

T —

Both (two mounting tabs)

Part Number Guide

OPB 9XX X XX X

Logic Type

Input

LED

Output

Logic State

Buffer

OFF

LOW = 0

Inverter

OFF

HIGH = 1

Applications:

For more information see Application notes 201, 213