DS229

3 of 9

V-: Negative supply output (RS-232). V- requires an external storage capacitor of at least 0.1

µF. A

larger capacitor (up to 10

µF) can be used to reduce supply ripple.

be left unconnected since each input has a 400 k

Ω pullup resistor.

loads up to 3 k

Ω. These driver outputs provide current necessary to meet RS-232 levels for loads up to

2500 pF.

5 k

Ω terminating resistor. Each receiver provides 0.5V hysteresis (typical) for noise immunity.

C1+, C1-, C2+, C2-: Charge pump capacitor inputs. These pins require two external capacitors (0.1

µF

minimum, 10

µF maximum and should be the same size as C3 and C4). Capacitor 1 is connected between

C1+ and C1-. Capacitor 2 is connected between C2+ and C2-. Capacitor C1 can be omitted if +12 volts is

connected directly to V+. Likewise, C2 can be omitted if -12V is connected directly to V-.

DUAL CHARGE PUMP CONVERTERS

The DS229 has a two stage on-board charge pump circuit that is used to generate

±10 volts from a single

+5-volt supply. In the first stage, capacitor C1 doubles the +5V supply to +10 volts which is then stored

on capacitor C3. The second stage uses capacitor C2 to invert the +10V potential to -10V. This charge is

then stored on capacitor C4. The

±10-volt supplies allow the DS229 to provide the necessary output

levels for RS-232 communication. The DS229 will operate with charge pump capacitors as low as 0.1

µF. Larger capacitors (up to 10 µF) can be used to reduce supply ripple.

RS-232 DRIVERS

The three RS-232 drivers are powered by the internal

±10-volt supplies generated by the on-board charge

pump. The driver inputs are both TTL and CMOS compatible. Each input has an internal 400 k

Ω=pullup

resistor so that unused transmitter inputs can be left unconnected. The open circuit output voltage swing

is from (V+ - 0.6) to V- volts. Worst case conditions for EIA-232E/V.28 of

±5 volts driving a 3 kΩ=load

swings of

±8 volts occur when loaded with a nominal 5 kΩ=RS-232 receiver. As required by EIA-232E

and V.28 specifications, the slew rate at the output is limited to less than 30 volts/

µs. Typical slew rates

are 20 volts/

µs unloaded and 12 volts/µs with 3 kΩ=and 2500 pF load. These slew rates allow for bit rates

of over 116 kbits/s. Driver outputs maintain high impedance when power is off.

RS-232 RECEIVERS

The three receivers conform fully to the RS-232E specifications. The input impedance is typically 5

k

Ω=and can withstand up to ±30 volts with or without V

The input switching thresholds are

within the

±3-volt limit of RS-232E specification with an input threshold low of 0.8 volts and an input

threshold high of 2.4 volts. The receivers have 0.5 volts of hysteresis (typical) to improve noise rejection.

The TTL/CMOS compatible outputs of the receivers will be low whenever the RS-232 input is greater

than 2.4 volts. The receiver output will be high when the input is floating or driven between +0.8 volts

and -25 volts.