CS2843ALDR14 datasheet(5/6 Pages) CHERRY

5 / 6 page

former saturation in some power supplies, the internal

oscillator waveform provides the maximum duty cycle

clamp as programmed by the selection of oscillator com-

ponents.

Setting the Oscillator

Oscillator timing capacitor, CT, is charged by VREF through

RT and discharged by an internal current source. During

the discharge time, the internal clock signal blanks out the

output to the Low state, thus providing a user selected

maximum duty cycle clamp. Charge and discharge times

are determined by the formula:

tc = RTCT ln

td = RTCT ln

Substituting in typical values for the parameters in the

above formulas:

VREF = 5.0V, Vupper = 2.7V, Vlower = 1.0V, Id = 8.3mA

tc ≈ 0.5534RTCT

td = RTCT ln

The frequency and maximum duty cycle can be deter-

mined using the Typical Performance Characteristic

graphs.

Grounding

High peak currents associated with capacitive loads neces-

sitate careful grounding techniques. Timing and bypass

capacitors should be connected close to Gnd pin in a sin-

gle point ground.

The transistor and 5kΩ potentiometer, shown in the test

circuit, are used to sample the oscillator waveform and

apply an adjustable ramp to Sense.

)

2.3 - 0.0083 RT

4.0 - 0.0083 RT

(

)

VREF - IdRT - Vlower

VREF - IdRT - Vupper

(

)

VREF - Vlower

VREF - Vupper

(

VREF

OSC

Gnd

Circuit Description: continued

VOSC

Internal Clock

LARGE RT (≈10kΩ)

VREF

Internal Clock

SMALL RT (≈700kΩ)

Sawtooth Mode

Triangular Mode

Vupper

Vlower

VCC

IOUT

VOUT

Switch

Current

EA Output

VOSC

OSC

RESET

Figure 2: Timing Diagram for key CS2841B parameters

Figure 3: Oscillator Timing Network and parameters

Timing parameters

CS2843ALDR14 датащи(PDF) 5 Page - Cherry Semiconductor Corporation

CS2843ALDR14 датащи(HTML) 5 Page - Cherry Semiconductor Corporation

Html Pages

1 2 3 4 5 6

датащи скачать

ссылки URL