CubeSuite+ Simulator for V850E2 supporting OS Timer V3.02.00

Release Note

R20UT2916EJ0100

Rev.1.00

Page 8 of 9

February 17, 2014

4.3

Cautions for Prism of Critical Blue

4.3.1 Cooperation of CubeSuite+simulator and Prism

The PEP which is included on the Prism package generates Prism information files (PGTS file and PGTI file)

from LM file. On the next step, prepare smplus_prism.ini which contains PGTS file and PGT file information.

CubeSuite+simulator will generate the Prism trace file based on smplus_prism.ini description by executing a

LM file. An analysis by the Prism is available on the above process.

4.3.2 Supported compiler

Only GHS compiler is supported. To analyze on Prism, please specify “-G –dual_debug” options for compiler.

4.3.3 Supported device

Only uPD70F3510 and 3512 are supported.

4.3.4 About .ini file

When the smplus_prism.ini exists in the same folder as CubeSuite+ project file or project subfolder, and

description of the file is correct, the CubeSuite+simulator will generate a trace file for the Prism. If there are

plural smplus_prism.ini files, the simulator reads the file from the most upper level sub folder.

Please write PGT file and PGTS file informations in the smplus_prism.ini. A maximum file name length is

255 characters including path. The smplus_prism.ini has to have full path information of files even if the files

are on the project folder. In case of tracing program which uses RI850V4, smplus_prism.ini has to contain an

address information for “