| поискавой системы для электроныых деталей |
|
RCM3365 датащи(PDF) 39 Page - List of Unclassifed Manufacturers |
|
|
|||||||||||||||||||||||||||||
RCM3365 датащи(HTML) 39 Page - List of Unclassifed Manufacturers |
|
39 / 165 page ![]() User’s Manual 33 4.1.1 Memory I/O Interface The Rabbit 3000 address lines (A0–A18) and all the data lines (D0–D7) are routed internally to the onboard flash memory and SRAM chips. I/0 write (/IOWR) and I/0 read (/IORD) are available for interfacing to external devices—pay attention to the loading on these two signals if you use them since these signals are also used by the RCM3365/ RCM3375. Parallel Port A can also be used as an external I/O data bus to isolate external I/O from the main data bus. Parallel Port B pins PB2–PB7 can also be used as an auxiliary address bus. When using the external I/O bus for a digital output or the LCD/keypad module on the Prototyping Board, or for any other reason, you must add the following line at the begin- ning of your program. #define PORTA_AUX_IO // required to enable external I/O bus 4.1.2 Other Inputs and Outputs The status, /RESET_IN, SMODE0, and SMODE1 I/O are normally associated with the programming port. Since the status pin is not used by the system once a program has been downloaded and is running, the status pin can then be used as a general-purpose CMOS output. The programming port is described in more detail in Section 4.2.3. /RES is an output from the reset circuitry that can be used to reset external peripheral devices. 4.1.3 LEDs The RCM3365/RCM3375 has five status LEDs located beside the RJ-45 Ethernet jack: ACT , LINK, SPEED, FM, and USR. The yellow ACT LED at DS1 indicates network activity. The green LINK LED at DS2 indicates that the RCM3365/RCM3375 is connected to a working network. The green SPEED LED at DS4 is on to indicate when the RCM3365/RCM3375 is con- nected to a 100Base-T Ethernet connection. The FM LED at DS3 blinks when data are being written to or read from the flash mass- storage device. The red USR LED at DS3 is a user-programmable LED, which is controlled by PD0 on the Rabbit 3000’s Parallel Port D. The sample program FLASHLED.C provided in the Dynamic C SAMPLES\RCM3360 folder shows how to set up and use this user- programmable LED. |
|
ссылки URL |
| Вашему бизинису помогли Аллдатащит? [ DONATE ] |
Что такое Аллдатащит | реклама | контакт | Конфиденциальность | Ссылка на техническое описание | обмен ссыками | поиск по производителю All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |