LP2986 datasheet(3/26 Pages) TI

3 / 26 page

using:

The value of

θJ−A for the SOIC-8 package is 160°C/W, and the VSSOP-8 package is 200°C/W. The value

LP2986

www.ti.com

SNVS137H – MARCH 1999 – REVISED APRIL 2013

Absolute Maximum Ratings

(1) (2)

Storage Temperature Range

−65°C to +150°C

Operating Junction Temperature Range

−40°C to +125°C

Lead Temperature (Soldering, 5 seconds)

260°C

ESD Rating(3)

2 kV

Power Dissipation(4)

Internally Limited

Input Supply Voltage (Survival)

−0.3V to +16V

Input Supply Voltage (Operating)

2.1V to +16V

Shutdown Pin

−0.3V to +16V

Feedback Pin

−0.3V to +5V

Output Voltage (Survival)(5)

−0.3V to +16V

IOUT (Survival)

Short Circuit Protected

Input-Output Voltage (Survival)(6)

−0.3V to +16V

(1)

Absolute Maximum Ratings indicate limits beyond which damage to the component may occur. Electrical specifications do not apply

when operating the device outside of its rated operating conditions.

(2)

If Military/Aerospace specified devices are required, please contact the Texas Instruments Sales Office/Distributors for availability and

specifications.

(3)

The ESD rating of the Feedback pin is 500V. The ESD rating of the VIN pin is 1kV and the Tap pin is 1.5 kV.

(4)

The maximum allowable power dissipation is a function of the maximum junction temperature, TJ(MAX), the junction-to-ambient thermal

resistance,

θJ−A, and the ambient temperature, TA. The maximum allowable power dissipation at any ambient temperature is calculated

θJ−A for the WSON package is specifically dependent on PCB trace area, trace material, and the number of layers and thermal vias. For

improved thermal resistance and power dissipation for the WSON package, refer to Application Note AN-1187. Exceeding the maximum

allowable power dissipation will cause excessive die temperature, and the regulator will go into thermal shutdown.

(5)

If used in a dual-supply system where the regulator load is returned to a negative supply, the LM2986 output must be diode-clamped to

ground.

(6)

The output PNP structure contains a diode between the V IN and VOUT terminals that is normally reverse-biased. Forcing the output

above the input will turn on this diode and may induce a latch-up mode which can damage the part (see Application Hints).

Submit Documentation Feedback

Product Folder Links: LP2986

LP2986 датащи(PDF) 3 Page - Texas Instruments

LP2986 датащи(HTML) 3 Page - Texas Instruments

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26

датащи скачать

ссылки URL