PIC16F882-I datasheet(102/328 Pages) MICROCHIP

102 / 328 page

PIC16F882/883/884/886/887

DS41291F-page 100

9.1

ADC Configuration

When configuring and using the ADC the following

functions must be considered:

• Port configuration

• Channel selection

• ADC voltage reference selection

• ADC conversion clock source

• Interrupt control

• Results formatting

9.1.1

PORT CONFIGURATION

The ADC can be used to convert both analog and digital

signals. When converting analog signals, the I/O pin

should be configured for analog by setting the associated

TRIS and ANSEL bits. See the corresponding Port

section for more information.

9.1.2

CHANNEL SELECTION

The CHS bits of the ADCON0 register determine which

channel is connected to the sample and hold circuit.

When changing channels, a delay is required before

starting the next conversion. Refer to Section 9.2

“ADC Operation” for more information.

9.1.3

ADC VOLTAGE REFERENCE

The VCFG bits of the ADCON0 register provide

independent control of the positive and negative

voltage references. The positive voltage reference can

be either VDD or an external voltage source. Likewise,

the negative voltage reference can be either VSS or an

external voltage source.

9.1.4

CONVERSION CLOCK

The source of the conversion clock is software select-

able via the ADCS bits of the ADCON0 register. There

are four possible clock options:

•FOSC/2

•FOSC/8

•FOSC/32

•FRC (dedicated internal oscillator)

The time to complete one bit conversion is defined as

TAD. One full 10-bit conversion requires 11 TAD periods

as shown in Figure 9-2.

For correct conversion, the appropriate TAD specification

must be met. See A/D conversion requirements in

Section 17.0 “Electrical Specifications” for more

information. Table 9-1 gives examples of appropriate

ADC clock selections.

Note:

Analog voltages on any pin that is defined

as a digital input may cause the input

buffer to conduct excess current.

Note:

Unless using the FRC, any changes in the

system clock frequency will change the

ADC

clock

frequency,

which

may

adversely affect the ADC result.

PIC16F882-I датащи(PDF) 102 Page - Microchip Technology

PIC16F882-I датащи(HTML) 102 Page - Microchip Technology

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

датащи скачать

ссылки URL