MDC009 datasheet(2/4 Pages) ETC2

2 / 4 page

SAFETY INSTRUCTIONS

Do not touch the nozzle or molten adhesive with bare skin as they are hot - the operating temperature of this tool is approximately 200ºC.

Protective gloves should always be worn. Careless handling can cause skin burns. If molten adhesive comes into contact with the skin immerse the

affected area immediately in plenty of cold water. Seek medical advice if necessary. In addition to the safety instructions herein, any statutory regulations, local

fire insurance regulations, or other generally valid “regulations for accident prevention” must be complied with when using this tool.

Repairs should only be undertaken by competent personnel with the adequate electrical knowledge. Before proceeding with any maintenance or repair

operation, disconnect the tool from the mains electricity supply. If in doubt, contact your supplier.

 Never use the tool if it is damaged in any way.

 Do not use this tool whilst under the influence of drugs or alcohol.

 Do not use this tool in damp rooms, outdoors whilst it is raining, or where there is high humidity.

 Do not use this tool in the vicinity of any heat-sensitive materials, or any flammable materials, liquids, or gases.

 Only use extension cables with a wire cross-section of 1.5mm2 / 16 a.w.g. and no more than 20m / 65 ft in length.

 Never pull on the tool’s connecting cable.

 This tool should only be used by children whilst under strict adult supervision.

Do Not connect to mains supply at this point!

Attach the tool stand.

Load the tool by inserting an

adhesive stick into the rear.

Operate the trigger to feed the stick

forward until resistance is felt.

Connect to mains supply.

Wait 5 minutes to warm.

Operate the trigger to extrude adhesive until

the stick has been completely drawn into the

rear of the tool.

MDC009 датащи(PDF) 2 Page - List of Unclassifed Manufacturers

MDC009 датащи(HTML) 2 Page - List of Unclassifed Manufacturers

Html Pages

1 2 3 4

датащи скачать

ссылки URL