29

Extended_Config

Address: 0x0b

Access: Read/Write

Reset Value: 0x00

Data Type: Bit field

USAGE: Register 0x0b allows the user to change the configuration of the sensor. Shown below are the bits, their default

values, and optional values.

Bit

7

6

5

4

3

2

1

0

Field

Busy

Reserved

Reserved

Reserved

Reserved

Serial_NPU

NAGC

Fixed_FR

Field Name

Description

Busy

Read-only bit. Indicates if it is safe to write to one or more of the following registers:

Frame_Period_Max_Bound_Upper and Lower

Frame_Period_Min_Bound_Upper and Lower

Shutter_Max_Bound_Upper and Lower

After writing to the Frame_Period_Max_Bound_Upper register, at least two frames must

pass before writing again to any of the above registers. This bit may be used in lieu of a timer

since the actual frame rate may not be known when running in auto mode.

0 = writing to the registers is allowed

1 = do not write to the registers yet

Reserved

Reserved

Reserved

Reserved

Reserved

Reserved

Reserved

Reserved

Serial_NPU

Disable serial port pull-up current sources

0 = no, current sources are on

1 = yes, current sources are off

NAGC

Disable AGC. Shutter will be set to the value in the Shutter_Max_Bound registers.

0 = no, AGC is active

1 = yes, AGC is disabled

Fixed_FR

Fixed frame rate (disable automatic frame rate control). When this bit is set, the frame rate

will be determined by the value in the Frame_Period_Max_Bound registers.

0 = automatic frame rate

1 = fixed frame rate

All rights strictly reserved any portion in this paper shall not be reproduced, copied or transformed to any other forms without permission.

PixArt Imaging Inc.

PixArt Imaging Inc.