14

SCLK

MOSI

Write Operation

Write operation, defined as data going from the micro-controller to the ADNS-3000, is always initiated by the micro-

controller and consists of two bytes. The first byte contains the address (seven bits) and has a “1” as its MSB to indicate

write sequence. The second byte contains the data. The ADNS-3000 reads MOSI on rising edges of SCLK.

MOSI setup and hold time during write operation

1

1

2

3

4

5

6

7

8

9

10

11

12

13

14

15

16

2

1

1

SCLK

NCS

MOSI

MOSI DRIVEN BY MICRO-CONTROLLER

MISO

MOSI delay and hold time during read operation

Read Operation

A read operation, defined as data going from the ADNS-3000 to the micro-controller, is always initiated by the micro-

controller and consists of two bytes. The first byte contains the address, is sent by the micro-controller over MOSI, and

has a “0” as its MSB to indicate data direction. The second byte contains the data and is driven by the ADNS-3000 over

MISO. The sensor outputs MISO bits on falling edges of SCLK and samples MOSI bits on every rising edge of SCLK.

Note: The 500 ns minimum high state of SCLK is also the minimum

MISO data hold time of the ADNS-3000. Since the falling edge of SCLK is

actually the start of the next read or write command, the ADNS-3000 will

hold the state of data on MISO until the falling edge of SCLK.

1

2

3

4

5

6

7

8

SCLK

Cycle #

SCLK

MOSI

0

9

10

11

12

13

14

15

16

NCS

MISO

SCLK

MISO

All rights strictly reserved any portion in this paper shall not be reproduced, copied or transformed to any other forms without permission.

PixArt Imaging Inc.

PixArt Imaging Inc.

ADNS-3000 Low Power Optical Mouse Sensor