LPC2104FBD48SLASH00 datasheet(19/41 Pages) PHILIPS

19 / 41 page

LPC2104_2105_2106_7

Product data sheet

Rev. 07 — 20 June 2008

19 of 41

NXP Semiconductors

LPC2104/2105/2106

Single-chip 32-bit microcontrollers

6.14.1 Features

• A 32-bit Timer/Counter with a programmable 32-bit Prescaler.

• Up to four (Timer 1) and three (Timer 0) 32-bit capture channels, that can take a

snapshot of the timer value when an input signal transitions. A capture event may also

optionally generate an interrupt.

• Four 32-bit match registers that allow:

– Continuous operation with optional interrupt generation on match.

– Stop timer on match with optional interrupt generation.

– Reset timer on match with optional interrupt generation.

• Up to four (Timer 1) and three (Timer 0) external outputs corresponding to match

registers, with the following capabilities:

– Set LOW on match.

– Set HIGH on match.

– Toggle on match.

– Do nothing on match.

6.14.2 Features available in LPC2104/2105/2106/01 only

The LPC2104/2105/2106/01 can count external events on one of the capture inputs if the

external pulse lasts at least one half of the period of the PCLK. In this conﬁguration,

unused capture lines can be selected as regular timer capture inputs or used as external

interrupts.

• Timer can count cycles of either the peripheral clock (PCLK) or an externally supplied

clock.

• When counting cycles of an externally supplied clock, only one of the timer’s capture

inputs can be selected as the timer’s clock. The rate of such a clock is limited to

PCLK

⁄

4. Duration of HIGH/LOW levels on the selected CAP input cannot be shorter

than 1

⁄

(2PCLK).

6.15 Watchdog timer

The purpose of the Watchdog is to reset the microcontroller within a reasonable amount of

time if it enters an erroneous state. When enabled, the Watchdog will generate a system

reset if the user program fails to ‘feed’ (or reload) the Watchdog within a predetermined

amount of time.

6.15.1 Features

• Internally resets chip if not periodically reloaded.

• Debug mode.

• Enabled by software but requires a hardware reset or a watchdog reset/interrupt to be

disabled.

• Incorrect/Incomplete feed sequence causes reset/interrupt if enabled.

• Flag to indicate watchdog reset.

LPC2104FBD48/00 датащи(PDF) 19 Page - NXP Semiconductors

LPC2104FBD48/00 датащи(HTML) 19 Page - NXP Semiconductors

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41

датащи скачать

ссылки URL