MCP7940MTIST datasheet(16/38 Pages) MICROCHIP

16 / 38 page

MCP7940M

DS22292A-page 16

Preliminary

 2012 Microchip Technology Inc.

5.2

RTCC/SRAM

5.2.1

SRAM BYTE WRITE

Following the Start condition from the master, the

control code and the R/W bit (which is a logic low) are

clocked onto the bus by the master transmitter. This

indicates to the addressed slave receiver that a byte

with a word address will follow after it has generated an

Acknowledge bit during the ninth clock cycle.

Therefore, the next byte transmitted by the master is

the word address and will be written into the Address

Pointer of the MCP7940M. After receiving another

Acknowledge signal from the MCP7940M, the master

device transmits the data word to be written into the

addressed

memory

location.

The

MCP7940M

acknowledges again and the master generates a Stop

condition. After a Byte Write command, the internal

address counter will point to the address location

following the one that was just written.

FIGURE 5-3:

SRAM BYTE WRITE

5.2.2

READ OPERATION

Read operations are initiated in the same way as write

operations with the exception that the R/W bit of the

control byte is set to one. There are three basic types

of read operations: current address read, random read,

and sequential read.

5.2.2.1

Current Address Read

The MCP7940M contains an address counter that

maintains the address of the last word accessed,

internally incremented by one. Therefore, if the

previous read access was to address n (n is any legal

address), the next current address read operation

would access data from address n + 1.

Upon receipt of the control byte with R/W bit set to one,

the MCP7940M issues an Acknowledge and transmits

the 8-bit data word. The master will not acknowledge

the transfer but does generate a Stop condition and the

MCP7940M discontinues transmission (Figure 5-4).

FIGURE 5-4:

CURRENT ADDRESS

READ

5.2.2.2

Random Read

Random read operations allow the master to access

any memory location in a random manner. To perform

this type of read operation, first the word address must

be set. This is done by sending the word address to the

MCP7940M as part of a write operation (R/W bit set to

‘0’). After the word address is sent, the master

generates a Start condition following the Acknowledge.

This terminates the write operation, but not before the

internal Address Pointer is set. Then, the master issues

the control byte again but with the R/W bit set to a one.

The MCP7940M will then issue an Acknowledge and

transmit the 8-bit data word. The master will not

acknowledge the transfer but it does generate a Stop

condition which causes the MCP7940M to discontinue

transmission (Figure 5-5). After a random Read

command, the internal address counter will point to the

address location following the one that was just read.

Note:

Addressing undefined SRAM locations will

result

the

MCP7940M

not

acknowledging the address.

BUS ACTIVITY

MASTER

SDA LINE

BUS ACTIVITY

CONTROL

BYTE

ADDRESS

BYTE

DATA

S 110 1

1 11

x = don’t care for 1K devices

BUS ACTIVITY

MASTER

SDA LINE

BUS ACTIVITY

CONTROL

BYTE

DATA

BYTE

11 1

MCP7940MTIST датащи(PDF) 16 Page - Microchip Technology

MCP7940MTIST датащи(HTML) 16 Page - Microchip Technology

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38

датащи скачать

ссылки URL