DocID024138 Rev 5

15/21

STGIPS20C60

Application information

5.1

Recommendations

• Input signal HIN is active high logic. A 85 kΩ (typ.) pull down resistor is built-in for each

high side input. If an external RC filter is used, for noise immunity, pay attention to the

variation of the input signal level.

• Input signal LIN is active low logic. A 720 kΩ (typ.) pull-up resistor, connected to an

internal 5 V regulator through a diode, is built-in for each low side input.

• To prevent the input signals oscillation, the wiring of each input should be as short as

possible.

• By integrating an application specific type HVIC inside the module, direct coupling to MCU

terminals without any opto-coupler is possible.

• Each capacitor should be located as nearby the pins of IPM as possible.

• Low inductance shunt resistors should be used for phase leg current sensing.

• Electrolytic bus capacitors should be mounted as close to the module bus terminals as

possible. Additional high frequency ceramic capacitor mounted close to the module pins

will further improve performance.

• The SD/OD signal should be pulled up to 5 V / 3.3 V with an external resistor (see

Section 4: Smart shutdown function for detailed info).

Note:

For further details refer to AN3338.

Table 13. Recommended operating conditions

Symbol

Parameter

Conditions

Value

Unit

Min.

Typ.

Max.

V

PN

Supply Voltage

Applied between P-Nu,Nv,Nw

300

400

V

V

CC

Control supply voltage

Applied between V

CC

-GND

13.5

15

18

V

V

BS

High side bias voltage

Applied between V

BOOTi

-OUT

i

for

i=U,V,W

13

18

V

t

dead

Blanking time to

prevent Arm-short

For each input signal

1.5

μs

f

PWM

PWM input signal

-40°C < T

c

< 100°C

-40°C < T

j

< 125°C

20

kHz

T

C

Case operation

temperature

100

°C