24LC22AT-ISLASHSN datasheet(4/24 Pages) MICROCHIP

4 / 24 page

24LC22A

DS21683B-page 4

2.0

FUNCTIONAL DESCRIPTION

The 24LC22A is designed to comply to the DDC Stan-

dard proposed by VESA (Figure 3-3) with the exception

that it is not Access.bus capable. It operates in two

modes, the Transmit-Only mode (1 Kbit) and the

Bidirectional mode (2 Kbit). There is a separate 2-wire

protocol to support each mode, each having a separate

clock input but sharing a common data line (SDA). The

device enters the Transmit-Only mode upon power-up.

In this mode, the device transmits data bits on the SDA

pin in response to a clock signal on the VCLK pin. The

device will remain in this mode until a valid high-to-low

transition is placed on the SCL input. When a valid tran-

sition on SCL is recognized, the device will switch into

the Bidirectional mode and look for its control byte to be

sent by the master. If it detects its control byte, it will

stay in the Bidirectional mode. Otherwise, it will revert

to the Transmit-Only mode after it sees 128 VCLK

pulses.

2.1

Transmit-Only Mode

The device will power-up in the Transmit-Only mode at

address 00h. This mode supports a unidirectional

2-wire protocol for continuous transmission of the first

1 Kbit of the memory array. This device requires that it

be initialized prior to valid data being sent in the Trans-

mit-Only mode (Section 2.2). In this mode, data is

transmitted on the SDA pin in 8-bit bytes, with each

byte followed by a ninth, Null bit (Figure 2-1). The clock

source for the Transmit-Only mode is provided on the

VCLK pin, and a data bit is output on the rising edge on

this pin. The eight bits in each byte are transmitted

Most Significant bit first. Each byte within the memory

array will be output in sequence. After address 7Fh in

the memory array is transmitted, the internal Address

Pointers will wrap-around to the first memory location

(00h) and continue. The Bidirectional mode Clock

(SCL) pin must be held high for the device to remain in

the Transmit-Only mode.

2.2

Initialization Procedure

After VCC has stabilized, the device will be in the

Transmit-Only mode. Nine clock cycles on the VCLK

pin must be given to the device for it to perform internal

sychronization. During this period, the SDA pin will be

in a high-impedance state. On the rising edge of the

tenth clock cycle, the device will output the first valid

data bit which will be the Most Significant bit in address

00h. (Figure 2-2).

FIGURE 2-1:

TRANSMIT-ONLY MODE

FIGURE 2-2:

DEVICE INITIALIZATION

SCL

SDA

VCLK

TVAA

Bit 1 (LSB)

Null Bit

Bit 1 (MSB)

Bit 7

TVLOW

TVHIGH

TVAA

Bit 8

Bit 7

High-Impedance for 9 Clock Cycles

TVPU

SCL

SDA

VCLK

Vcc

24LC22AT-I/SN датащи(PDF) 4 Page - Microchip Technology

24LC22AT-I/SN датащи(HTML) 4 Page - Microchip Technology

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24

датащи скачать

ссылки URL