STM32F050C6T6A datasheet(14/97 Pages) STMICROELECTRONICS

14 / 97 page

Functional overview

STM32F050xx

14/97

Doc ID 023683 Rev 1

3.5.3

Voltage regulator

The regulator has three operating modes: main (MR), low power (LPR) and power down.

●

MR is used in normal operating mode (Run)

●

LPR can be used in Stop mode where the power demand is reduced

●

Power down is used in Standby mode: the regulator output is in high impedance: the

kernel circuitry is powered down, inducing zero consumption (but the contents of the

registers and SRAM are lost)

This regulator is always enabled after reset. It is disabled in Standby mode, providing high

impedance output.

3.5.4

Low-power modes

The STM32F050xx family supports three low-power modes to achieve the best compromise

between low power consumption, short startup time and available wakeup sources:

●

Sleep mode

In Sleep mode, only the CPU is stopped. All peripherals continue to operate and can

wake up the CPU when an interrupt/event occurs.

●

Stop mode

Stop mode achieves very low power consumption while retaining the content of SRAM

and registers. All clocks in the 1.8 V domain are stopped, the PLL, the HSI RC and the

HSE crystal oscillators are disabled. The voltage regulator can also be put either in

normal or in low power mode.

The device can be woken up from Stop mode by any of the EXTI lines. The EXTI line

source can be one of the 16 external lines, the PVD output, RTC alarm, I2C1 or

USART1.

The I2C1 and the USART1 can be configured to enable the HSI RC oscillator for

processing incoming data. If this is used, the voltage regulator should not be put in the

low-power mode but kept in normal mode.

●

Standby mode

The Standby mode is used to achieve the lowest power consumption. The internal

voltage regulator is switched off so that the entire 1.8 V domain is powered off. The

PLL, the HSI RC and the HSE crystal oscillators are also switched off. After entering

Standby mode, SRAM and register contents are lost except for registers in the Backup

domain and Standby circuitry.

The device exits Standby mode when an external reset (NRST pin), a IWDG reset, a

rising edge on the WKUP pins, or an RTC alarm occurs.

Note:

The RTC, the IWDG, and the corresponding clock sources are not stopped by entering Stop

or Standby mode.

STM32F050C6T6A датащи(PDF) 14 Page - STMicroelectronics

STM32F050C6T6A датащи(HTML) 14 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97

датащи скачать

ссылки URL