TLV271CDBVT datasheet(14/34 Pages) TI1

14 / 34 page

TLV271, TLV272, TLV274

FAMILY OF 550 µA/Ch 3MHz RAILTORAIL OUTPUT

OPERATIONAL AMPLIFIERS

SLOS351D − MARCH 2001 − REVISED FEBRUARY 2004

WWW.TI.COM

APPLICATION INFORMATION

circuit layout considerations

To achieve the levels of high performance of the TLV27x, follow proper printed-circuit board design techniques.

A general set of guidelines is given in the following.

D Ground planes—It is highly recommended that a ground plane be used on the board to provide all

components with a low inductive ground connection. However, in the areas of the amplifier inputs and

output, the ground plane can be removed to minimize the stray capacitance.

D Proper power supply decoupling—Use a 6.8-µF tantalum capacitor in parallel with a 0.1-µF ceramic

capacitor on each supply terminal. It may be possible to share the tantalum among several amplifiers

depending on the application, but a 0.1-

µF ceramic capacitor should always be used on the supply terminal

of every amplifier. In addition, the 0.1-

µF capacitor should be placed as close as possible to the supply

terminal. As this distance increases, the inductance in the connecting trace makes the capacitor less

effective. The designer should strive for distances of less than 0.1 inches between the device power

terminals and the ceramic capacitors.

D Sockets—Sockets can be used but are not recommended. The additional lead inductance in the socket pins

will often lead to stability problems. Surface-mount packages soldered directly to the printed-circuit board

is the best implementation.

D Short trace runs/compact part placements—Optimum high performance is achieved when stray series

inductance has been minimized. To realize this, the circuit layout should be made as compact as possible,

thereby minimizing the length of all trace runs. Particular attention should be paid to the inverting input of

the amplifier. Its length should be kept as short as possible. This helps to minimize stray capacitance at the

input of the amplifier.

D Surface-mount passive components—Using surface-mount passive components is recommended for high

performance amplifier circuits for several reasons. First, because of the extremely low lead inductance of

surface-mount components, the problem with stray series inductance is greatly reduced. Second, the small

size of surface-mount components naturally leads to a more compact layout thereby minimizing both stray

inductance and capacitance. If leaded components are used, it is recommended that the lead lengths be

kept as short as possible.

TLV271CDBVT датащи(PDF) 14 Page - Texas Instruments