PIC18LF2X datasheet(2/44 Pages) MICROCHIP

2 / 44 page

PIC18(L)F2X/4XK50

DS41630B-page 2

 2012 Microchip Technology Inc.

2.2.1

ICPORT DISABLED

Clearing the ICPRT bit in CONFIG4L disables the use

of the dedicated port function and leaves the dedicated

pins

floating.

High-voltage

and

low-voltage

programming are performed using the MCLR/VPP,

PGC and PGD pins as normal. This is otherwise known

as the legacy interface mode, using the standard

interface pins.

2.2.2

ICPORT ENABLED

Setting the ICPRT bit in CONFIG4L enables the use of

the dedicated port function through the dedicated pins.

This is the default setting for the ICPRT bit upon start-

up or Reset. When using devices in packages other

than the 44-pin TQFP, the ICPRT bit must be cleared.

The standard interface pins will remain operational,

even after the dedicated pins are enabled, unless the

user assigns another function to them in firmware. If

another function is not assigned to the standard pins

and both sets of pins remain operable for program-

ming, whichever high-voltage entry pin (the standard

VPP pin or the dedicated ICDVPP pin) is activated first

will take priority.

For high-voltage programming, if high-voltage is

detected on the ICDVPP pin first, the standard MCLR/

VPP pin will be ignored and programming must be

performed using the ICDPGC and ICDPGD pins. If

high-voltage is detected on the MCLR/VPP pin first, the

dedicated ICDVPP pin will be ignored and programming

must be performed using the PGC and PGD pins.

These

same

rules

apply

the

low-voltage

programming sequence.

2.3

Pin Diagrams

The pin diagrams for the PIC18(L)F2X/4XK50 family

are shown in Figures 2-1 through 2-4.

TABLE 2-1:

PIN DESCRIPTIONS (DURING PROGRAMMING): PIC18(L)F2X/4XK50

Pin Name

During Programming

Pin Type

Pin Description

MCLR/VPP/RE3

VPP

Programming Enable

VDD(1)

VDD

Power Supply

VSS(1)

VSS

PGround

RB6

PGC

Serial Clock

RB7

PGD

I/O

Serial Data

ICDRST/ICDVPP(2)

VPP

Programming Enable

ICDCLK/ICDPGC

PGC

Serial Clock

ICDDAT/ICDPGD(2)

PGD

I/O

Serial Data

Legend: I = Input, O = Output, P = Power

Note 1:

All power supply (VDD) and ground (VSS) pins must be connected.

Dedicated ICSP/ICD Port available on 44-pin TQFP only when the ICPRT bit in CONFIG4L is enabled.

PIC18LF2X датащи(PDF) 2 Page - Microchip Technology

PIC18LF2X датащи(HTML) 2 Page - Microchip Technology

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44

датащи скачать

ссылки URL