QG80331M800 datasheet(50/67 Pages) INTEL

50 / 67 page

Specification Update

Intel® 80331 I/O Processor

Specification Changes

‘Issue EMRS3 command’. In order to be JEDEC compliant, these steps should be added to the

memory controller initialization sequence.

Note: Before implementing, check with your DIMM/memory manufacturer to determine if these

steps are necessary. Software should always follow the initialization sequence provided by the

DIMM/memory manufacturer guidelines.

The following pseudo code shows the EMRS initialization steps that are required to be compliant

with the JEDEC DDR-II initialization sequence.

// Step 5 and 6 - EMRS(2) and EMRS(3) programming

if MemoryType is DDR-II

Write 0x2 to DCALADDR (Setting BA[1:0] for EMRS(2))

Write 0x81000003 to DCALCSR (issue EMRS command to CS0)

Wait for DCALCSR[31] to report ‘Operation Completed’

Write 0x81100003 to DCALCSR (issue EMRS command to CS1)

Wait for DCALCSR[31] to report ‘Operation Completed’

Write 0x3 to DCALADDR (Setting BA[1:0] for EMRS(3))

Write 0x81000003 to DCALCSR (issue EMRS command to CS0)

Wait for DCALCSR[31] to report ‘Operation Completed’

Write 0x81100003 to DCALCSR (issue EMRS command to CS1)

Wait for DCALCSR[31] to report ‘Operation Completed’

endif

21.

Case temperature (Tcase) change

Issue:

To be consistent with the production test environment, the case temperature (Tcase) for the 80331

I/O processor has been changed from 105ο c to 95ο c.

22.

Internal Clock Misalignment

Issue:

Due to non-core Erratum 62, Internal Clock Misalignment Can Cause Processor Hang, on page 41,

Intel is screening parts to eliminate the probability of occurrence. Until this is fixed in a future

stepping, a screen has been implemented which will screen out parts exhibiting this issue with a

VCC15 greater than 1.46v.

With the screen at 1.46v, the on-board 1.5v power rail should not be allowed to go below 1.46v, as

this would increase the risk of failure. The 1.5v rail minimum is currently specified in the datasheet

as 1.425v, therefore for screened parts, the minimum is changed to 1.46v.

Status:

Fixed. This issue was fixed in the D-1 stepping of the product.

QG80331M800 датащи(PDF) 50 Page - Intel Corporation