ACT4808LDF datasheet(5/8 Pages) AEROFLEX

5 / 8 page

Aeroflex Circuit Technology

SCD4808 REV E 12/9/99

Plainview NY (516) 694-6700

Notes:

1. VCC = +15Volts ±0.75V, VEE = -15Volts ±0.75V, VIL = +5Volts ±0.5V, TC = -55°C to +125°C, unless otherwise

specified.

2. All typical values are measured at +25°C.

3. Characteristics guaranteed by design, not production tested.

4. Power ON/OFF, measured from 75KHz to 1MHz at Point A-A’ Figure 4, in accordance with MIL-STD-1553B

paragraph 4.5.2.2.2.3.

5. At point A-A’ on Figure 3 or 4, 2.5 µS after midpoint crossing of the parity bit of the last word of a 660 µS message.

6. Receiver skew is defined as the time from the rising edge of RX DATA OUT to the rising edge of RX DATA OUT

minus 500 nS, with a sine wave input of 3 VPK-PK at 1MHz driven into Pt. B-B’ of Figure 4 or 2.1 VPK-PK at 1MHz

driven into Pt. B-B’ of Figure 3. The specification maximum is guaranteed for TA = 25°C only. Standard TTL loads

applied to RX DATA Outputs.

7. This test is peformed while the Transceiver is reading its own transmission. This condition is called "Wraparound".

Standard TTL loads applied to RX DATA Outputs.

Typical Hybrid Power Dissipation

*, Per Channel

Power

Supply

Conditions

Condition

Std Version

-L Version

Unit

Standby

100%

Duty

Cycle

Standby

100%

Duty

Cycle

PSC1

VCC = +15V

VEE = -15V

VL = +5V

Pt. B - B’

ZO = 70 Ω,

VO = 29 VPK-PK

Bit Pattern = FFFF

HEX

Fig. 4

1.325

3.250

0.540

2.167

Watts

PSC2

VCC = +15V

VEE = -12V

VL = +5V

1.118

3.142

0.465

1.852

PSC3

VCC = +12V

VEE = -12V

VL = +5V

1.085

2.472

0.450

1.600

* See Aeroflex Application note# 112 for reference.

Recommended Power Supply Voltage Range

+11.4 Volts to +15.75 Volts

-V

-11.4 Volts to -15.75 Volts

Logic

+4.5 Volts to +5.5 Volts

ACT4808LDF датащи(PDF) 5 Page - Aeroflex Circuit Technology

ACT4808LDF датащи(HTML) 5 Page - Aeroflex Circuit Technology

Html Pages

1 2 3 4 5 6 7 8

датащи скачать

ссылки URL