KTPF0100UG datasheet(4/74 Pages) FREESCALE

4 / 74 page

KTPF0100UG, Rev. 2.0

Freescale Semiconductor

Introduction

The KITPF0100EPEVBE evaluation board allows full evaluation capability of the PF0100 PMIC for the i.MX6

family of application processors. It provides access to all output voltage rails as well as control and signal pins

through terminal block connectors for an easier out-of-the-box evaluation experience. A single terminal block

connector for the input power supply allows the user to supply the board with an external DC power supply to fully

evaluate the performance of the device.

The KITPF0100EPEVBE comes with a non-programmed version of the PF0100 PMIC, so it is prepared to power

up from the default sequence. However, an integrated control/fuse programming interface is provided to allow the

customer to program the OTP/TBB (One Time Programmable/Try-Before-Buy) memory and also to select it as the

default source for the power-up configuration. Likewise, the programming interface allows full control of the

PF0100 through the I2C communication lines.

This document is intended to provide an overview of the KITPF0100EPEVBE evaluation board as well as detailed

instruction for programming the PF0100 through its dedicated Graphic User Interface (GUI).

Note: This document provides updated information on the installation and use of the current PF0100 EVK Control

GUI, revision 3.0.0.20. Some discrepancies may be found if using an earlier version of the GUI. To learn about the

version of the GUI you are using, please refer to section “Graphical User Interface Description”.

KITPF0100EPEVBE Features

•

Input voltage operation range from 3.1 V to 4.5 V

•

Output voltage supplies accessible through detachable terminal blocks

•

Four to six independent buck converters

•

One 5.0 V boost regulator

•

Six general purpose LDO regulators

•

One DDR memory termination voltage reference

•

One VSRTC supply

•

Coin cell support for “Try-Before-Buy” (TBB) mode

•

On/off push button support

•

Hardware configuration flexibility through various jumper headers and resistors

•

Integrated USB to I2C programming interface for full control/configuration

•

Onboard OTP programming supply and control

•

Onboard PMIC control through the I2C register map

•

Fully featured programmer through J36 for external device control/programming

•

On board connectors for interfacing with future evaluation/debug tools

•

Compact form factor (4 x 4 in2)

KTPF0100UG датащи(PDF) 4 Page - Freescale Semiconductor, Inc

KTPF0100UG датащи(HTML) 4 Page - Freescale Semiconductor, Inc

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74

датащи скачать

ссылки URL