WM8904ECSSLASHR datasheet(47/188 Pages) WOLFSON

47 / 188 page

Pre-Production

WM8904

PP, Rev 3.3, September 2012

DIGITAL MICROPHONE INTERFACE

The WM8904 supports a stereo digital microphone interface. This may be provided on DMICDAT1 or

on DMICDAT2, as selected by the DMIC_SRC register bit. The analogue signal path from the

selected input pin must be disabled when using the digital microphone interface; this is achieved by

configuring or disabling the associated input PGA.

The two-channel audio data is multiplexed on the selected input pin. The associated clock,

DMICCLK, is provided on a GPIO pin.

The Digital Microphone Input is selected as input by setting the DMIC_ENA bit. When the Digital

Microphone Input is selected, the ADC is bypassed.

The digital microphone interface configuration is illustrated in Figure 27.

Note that care must be taken to ensure that the respective digital logic levels of the microphone are

compatible with the digital input thresholds of the WM8904. The digital input thresholds are

referenced to DBVDD, as defined in “Electrical Characteristics”. It is recommended to power the

digital microphones from DBVDD.

Figure 27 Digital Microphone Interface

When any GPIO pin is configured as DMIC Clock output, the WM8904 outputs a clock, which

supports Digital Microphone operation at the ADC sampling rate. The ADC and Record Path filters

must be enabled and the ADC sampling rate must be set in order to ensure correct operation of all

DSP functions associated with the digital microphone. Volume control for the Digital Microphone

Interface signals is provided using the ADC Volume Control.

See “Analogue-to-Digital Converter (ADC)” for details of the ADC Enable and volume control

functions. See “General Purpose Input/Output (GPIO)” for details of configuring the DMICCLK output.

See “Clocking and Sample Rates” for details of the sample rate control.

When the DMIC_ENA bit is set, then the IN1L/DMICDAT1 or IN1R/DMICDAT2 pin is used as the

digital microphone input DMICDAT. Up to two microphones can share each pin; the two microphones

are interleaved as illustrated in Figure 28.

WM8904ECS/R датащи(PDF) 47 Page - Wolfson Microelectronics plc