Getting Started

www.ti.com

•

Isolated/Standalone – Used to protect the host PC while debugging the application, which may present

dangerous voltages to a PC or when the user wants to run a standalone application with a single

supply. Power for the entire system (both LaunchPad and LED BoosterPack) is supplied from the 12 V

AC/DC wall adapter. The USB can be optionally connected if the user wants to debug the application;

in this case, power for the emulator is supplied via USB. This mode provides the user with 2500 Vrms

of isolation to protect the computer in the event that dangerous transient voltages are present on the

board.

–

Jumpers JP1, JP2, and JP3 on the LaunchPad should NOT have jumpers placed on each post.

–

Jumpers J2 and J8 on the LED BoosterPack should have jumpers placed on each post.

–

Connect the USB (optional, only used for debugging) to the LaunchPad.

–

Connect the included power adapter to the LED BoosterPacks’ J1.

3.3

Boot Modes

Table 1 describes the switch settings that are needed for emulation boots as well as booting from FLASH

or SCI for the board.

Table 1. Boot Options

Emulation Boot

Boot From FLASH

Boot From SCI

SW1 on LaunchPad

SW1 on LaunchPad

SW1 on LaunchPad

Position 1 = up

Position 1 = up

Position 1 = up

F2802x

Position 2 = up

Position 2 = up

Position 2 = down

Position 3 = up

Position 3 = down

Position 3 = down

4

Getting Started

4.1

PC GUI Demo

The LED BoosterPack experimenter’s kit comes with a GUI that provides a convenient way to evaluate the

functionality of this kit and the F28027 device without having to learn and configure the underlying project

software. The interactive interface using sliders, buttons, and textboxes allows LED lighting with the

C2000 device to be demonstrated quickly and easily.

4.1.1

Hardware Setup for PC GUI Demo

Perform or verify the following steps to prepare the LED BoosterPack for use with the included GUI:

1. Verify the following jumper and switch settings on the LED BoosterPack.

(a) A jumper is not placed on J2.

(b) A jumper is not placed on J8.

(c) The switch S1 is in the down position.

2. Verify the following jumper and switch settings on the C2000 LaunchPad:

(a) A jumper is placed on JP1.

(b) A jumper is placed on JP2.

(c) A jumper is placed on JP3.

(d) Switches in S1 are all in the up position.

(e) The switch S4 is in the up position.

3. Insert a C2000 LaunchPad into the header marked J3, J9 and J4, J10.

4. Connect the LED BoosterPack to the included power adapter and plug in the adapter to the mains

power.

5. Connect the LaunchPad to the PC using the USB cable included with the C2000 LaunchPad.

8

C2000 LED BoosterPack

SPRUHH9 – July 2012

Submit Documentation Feedback

Copyright © 2012, Texas Instruments Incorporated