ADS1248EVM-PDK Kit Operation

www.ti.com

7.3

Default Jumper Settings and Switch Positions

Figure 3 shows the jumpers found on the EVM and the respective factory default conditions for each.

Figure 3. ADS1248EVM Default Jumper Locations

Table 6 lists the switches found on the EVM and the respective factory default conditions for each.

Table 6. List of Switches

Switch

Default Position

Switch Description

S1

Left

Onboard reference

8

ADS1248EVM-PDK Kit Operation

This section provides information on using the ADS1248EVM-PDK, including setup, program installation,

and program usage.

To prepare to evaluate the ADS1248 with the ADS1248EVM-PDK, complete the following steps:

Step 1.

Install the ADCPro software (if not already installed) on a PC.

Step 2.

Install the ADS1248EVM-PDK EVM plug-in software.

Step 3.

Complete the USB driver installation process.

Step 4.

Set up the ADS1248EVM-PDK.

Step 5.

Connect the ADS1248EVM-PDK to the computer with a USB cable.

Step 6.

Run the ADCPro software.

Each task is described in the subsequent sections of this document.

8

ADS1148EVM, ADS1248EVM, ADS1148EVM-PDK, and ADS1248EVM-PDK

SBAU142B

– April 2009 – Revised May 2011

Submit Documentation Feedback

Copyright

© 2009–2011, Texas Instruments Incorporated