7

Atmel AT24CS01/02 [PRELIMINARY DATASHEET]

8815A–SEEPR–6/12

7.

Device Operation

Clock and Data Transitions: The SDA pin is normally pulled high with an external device. Data on the SDA pin may

change only during SCL low time periods (see Figure 7-4 on page 9). Data changes during SCL high periods will indicate

a Start or Stop condition as defined below.

Start Condition: A high-to-low transition of SDA with SCL high is a Start condition which must precede any other

command (see Figure 7-5 on page 9).

Stop Condition: A low-to-high transition of SDA with SCL high is a Stop condition. After a read sequence, the Stop

command will place the EEPROM in a standby power mode (see Figure 7-5 on page 9).

Acknowledge: All addresses and data words are serially transmitted to and from the EEPROM in 8-bit words. The

EEPROM sends a zero to acknowledge that it has received each word. This happens during the ninth clock cycle.

Standby Mode: The AT24CS01/02 features a low-power standby mode which is enabled upon power-up as well as after

the receipt of the Stop bit and the completion of any internal operations.

2-wire Software Reset: After an interruption in protocol, power loss, or system reset, any 2-wire part can be reset by

following these steps:

1.

Create a start bit condition.

2.

Clock nine cycles.

3.

Create another start bit followed by stop bit condition as shown in Figure 7-1.

The device is ready for next communication after above steps have been completed.

Figure 7-1. Software reset

SCL

9

Start

Bit

Start

Bit

Stop

Bit

8

3

2

1

SDA

Dummy Clock Cycles