| поискавой системы для электроныых деталей |
|
UBA2021 датащи(PDF) 10 Page - NXP Semiconductors |
|
|
|||||||||||||||||||||||||||||
UBA2021 датащи(HTML) 10 Page - NXP Semiconductors |
|
10 / 16 page ![]() UBA2021_4 © NXP B.V. 2008. All rights reserved. Product data sheet Rev. 04 — 25 July 2008 10 of 16 NXP Semiconductors UBA2021 630 V driver IC for CFL and TL lamps [1] The start-up supply current is specified in a temperature (Tvj) range of 0 °C to 125 °C. For Tvj <0 °C and Tvj >125 °C the start-up supply current is < 350 µA. [2] The clamp margin is defined as the voltage difference between turn-on of the clamp and start of oscillation. The clamp is in the off-state at start of oscillation. [3] Data sampling of VRS(ctrl) is performed at the end of conduction of T2. [4] The total supply current is specified in a temperature (Tvj) range of −20 °C to +125 °C. For Tvj < −20 °C and Tvj >125 °C the total supply current is < 1.5 mA. [5] Data sampling of VRS(cap) is performed at the start of conduction of T2. [6] Within the allowed range of RRREF, defined as 30 kΩ +10 %. [7] Typical values for the on and off resistances at Tvj = 87.5 °C are: RG2(on) and RG1(on) = 164 Ω, RG2(off) and RG1(off) = 100 Ω. [8] The input current at RHV pin may increase to 1600 µA during voltage transient at V in. Only for currents IRHV beyond approximately 550 µA is the oscillator frequency proportional to I RHV. [9] The symmetry SYMff is calculated from the quotient SYMff = T1tot / T2tot, with T1tot the time between turn-off of G2 and turn-off of G1, and T2tot the time between turn-off of G1 and turn-off of G2. 11. Design information 11.1 Design equations • Bottom frequency: (1) • Feed-forward frequency: (2) • Where: – X1 = 3.68. – X2 = 22.28. – τ = 0.4 µs. – Rint = 3 kΩ. – Cpar = 4.7 pF • Operating frequency is the maximum of fB, fff or fcm. fff feed-forward frequency IRHV = 0.75 mA 60.4 63.6 66.15 kHz IRHV = 1 mA 80.3 84.5 88.2 kHz SYMff symmetry IRHV = 1 mA [9] 0.9 1 1.1 RR ripple rejection fVin = 100 Hz - 6 - dB RCP(sw) CP switch series resistance ICP = 100 µA 0.75 1.5 2.25 k Ω RAV averaging resistor ICP = 10 µA 22.4 32 41.6 k Ω Table 7. Characteristics …continued VVS = 11 V; VFS - VS1 = 11 V; Tamb = 25 °C; all voltages referenced to ground; unless otherwise specified. See Figure 8. Symbol Parameter Conditions Min Typ Max Unit f B 1 2C CF C par + () X1 R RREF R int – × () × [] τ + {} × ------------------------------------------------------------------------------------------------------------------------ = f ff 1 2C CF C par + () X2 V RREF × I i RHV () ------------------------------ R int – ×τ + × -------------------------------------------------------------------------------------------------------------------------- = |
|
|
ссылки URL |
| Вашему бизинису помогли Аллдатащит? [ DONATE ] |
Что такое Аллдатащит | реклама | контакт | Конфиденциальность | Ссылка на техническое описание | обмен ссыками | поиск по производителю All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |