B75-1B20-KOF datasheet(2/8 Pages) MAGNETROL

2 / 8 page

42-686 Series K Pneumatic Switch Mechanism

Read this Manual Before Installing

This manual provides information on the Series K

Pneumatic Switch Mechanism. It is important that all

instructions are read carefully and followed in sequence.

Detailed installation and hook-up instructions are included

in this manual.

Conventions Used in this Manual

Certain conventions are used in this manual to convey

specific types of information. General technical material,

support data, and safety information are presented in

narrative form. The following styles are used for notes,

cautions, and warnings.

Notes

Notes contain information that augments or clarifies an

operating step. Notes do not normally contain actions.

They follow the procedural steps to which they refer.

Cautions

Cautions alert the technician to special conditions that

could injure personnel, damage equipment, or reduce

a component’s mechanical integrity. Cautions are also

used to alert the technician to unsafe practices or the

need for special protective equipment or specific

materials. In this manual, a caution box indicates a

potentially hazardous situation which, if not avoided,

may result in minor or moderate injury.

Warnings

Warnings identify potentially dangerous situations or

serious hazards. In this manual, a warning indicates an

imminently hazardous situation which, if not avoided,

could result in serious injury or death.

Safety Messages

Follow all standard industry procedures for servicing elec-

trical equipment when working with or around high

voltage. Always shut off the power supply before touching

any components.

Low Voltage Directive

For use in Installations Category II, Pollution Degree 2.

If equipment is used in a manner not specified by the

manufacturer, protection provided by equipment may

be impaired.

Notice of Copyright, and Limitations

Magnetrol reserves the right to make changes to the

product described in this manual at any time without

notice. Magnetrol makes no warranty with respect to the

accuracy of the information in this manual.

Warranty

All Magnetrol mechanical level and flow controls are war-

ranted free of defects in materials or workmanship for five

full years from the date of original factory shipment.

If returned within the warranty period; and, upon factory

inspection of the control, the cause of the claim is

determined to be covered under the warranty; then,

Magnetrol will repair or replace the control at no cost to the

purchaser (or owner) other than transportation.

Magnetrol shall not be liable for misapplication, labor

claims, direct or consequential damage or expense arising

from the installation or use of equipment. There are no

other warranties expressed or implied, except special

written warranties covering some Magnetrol products.

Quality Assurance

The quality assurance system in place at Magnetrol guar-

antees the highest level of quality throughout the

company. Magnetrol is committed to providing full cus-

tomer satisfaction both in quality products and quality

service.

Magnetrol’s quality assurance system is

registered to ISO 9001 affirming its

commitment to known international

quality

standards

providing

the

strongest assurance of product/service

quality available.

B75-1B20-KOF датащи(PDF) 2 Page - Magnetrol International, Inc.

B75-1B20-KOF датащи(HTML) 2 Page - Magnetrol International, Inc.

Html Pages

1 2 3 4 5 6 7 8

датащи скачать

ссылки URL