Alarm Threshold Registers

There are seven alarm threshold registers that store

overtemperature ALERT and OVERT threshold values.

Five of these registers are dedicated to store one local

alert temperature threshold limit and four remote alert

temperature threshold limits (see the ALERT Interrupt

Mode section). The remaining two registers are dedi-

cated to remote channels 1 and 4 to store overtemper-

ature threshold limits (see the OVERT Overtemperature

Alarm section). Access to these registers is provided

through the SMBus interface.

ALERT Interrupt Mode

An ALERT interrupt occurs when the internal or external

temperature reading exceeds a high-temperature limit

(user programmable). The ALERT interrupt output signal

can be cleared by reading the status register(s) associ-

ated with the fault(s) or by successfully responding to an

alert response address transmission by the master. In

both cases, the alert is cleared but is reasserted at the

end of the next conversion if the fault condition still

exists. The interrupt does not halt automatic conversions.

The ALERT output is open drain so that multiple devices

can share a common interrupt line. All ALERT interrupts

can be masked using the configuration 3 register. The

POR state of these registers is shown in Table 1.

Five-Channel Precision Temperature Monitor

_______________________________________________________________________________________

9

SMBCLK

A = START CONDITION

B = MSB OF ADDRESS CLOCKED INTO SLAVE

C = LSB OF ADDRESS CLOCKED INTO SLAVE

D = R/W BIT CLOCKED INTO SLAVE

AB

C

D

E

FG

HI

J

SMBDATA

LM

K

E = SLAVE PULLS SMBDATA LINE LOW

F = ACKNOWLEDGE BIT CLOCKED INTO MASTER

G = MSB OF DATA CLOCKED INTO SLAVE

H = LSB OF DATA CLOCKED INTO SLAVE

I = MASTER PULLS DATA LINE LOW

J = ACKNOWLEDGE CLOCKED INTO SLAVE

K = ACKNOWLEDGE CLOCK PULSE

L = STOP CONDITION

M = NEW START CONDITION

Figure 3. SMBus Write Timing Diagram

SMBCLK

AB

C

D

E

FG

H

I

J

K

SMBDATA

A = START CONDITION

B = MSB OF ADDRESS CLOCKED INTO SLAVE

C = LSB OF ADDRESS CLOCKED INTO SLAVE

D = R/W BIT CLOCKED INTO SLAVE

E = SLAVE PULLS SMBDATA LINE LOW

L

M

F = ACKNOWLEDGE BIT CLOCKED INTO MASTER

G = MSB OF DATA CLOCKED INTO MASTER

H = LSB OF DATA CLOCKED INTO MASTER

I = MASTER PULLS DATA LINE LOW

J = ACKNOWLEDGE CLOCKED INTO SLAVE

K = ACKNOWLEDGE CLOCK PULSE

L = STOP CONDITION

M = NEW START CONDITION

Figure 4. SMBus Read Timing Diagram