DS1985

19 of 26

Match ROM [55H]

The Match ROM command, followed by a 64-bit ROM sequence, allows the bus master to address a

specific DS1985 on a multidrop bus. Only the DS1985 that exactly matches the 64-bit ROM sequence

will respond to the subsequent memory function command. All slaves that do not match the 64-bit ROM

sequence will wait for a Reset Pulse. This command can be used with a single or multiple devices on the

bus.

Skip ROM [CCH]

This command can save time in a single drop bus system by allowing the bus master to access the

memory functions without providing the 64-bit ROM code. If more than one slave is present on the bus

and a read command is issued following the Skip ROM command, data collision will occur on the bus as

multiple slaves transmit simultaneously (open drain pulldowns will produce a wired-AND result).

Search ROM [F0H]

When a system is initially brought up, the bus master might not know the number of devices on the 1-

Wire bus or their 64-bit ROM codes. The Search ROM command allows the bus master to use a process

of elimination to identify the 64-bit ROM codes of all slave devices on the bus. The ROM search process

is the repetition of a simple three-step routine: read a bit, read the complement of the bit, then write the

desired value of that bit. The bus master performs this simple, three-step routine on each bit of the ROM.

After one complete pass, the bus master knows the contents of the ROM in one device. The remaining

number of devices and their ROM codes may be identified by additional passes. See Chapter 5 of the

Book of DS19xx iButton Standards for a comprehensive discussion of a ROM search, including an actual

example.

1-Wire Signaling

The DS1985 requires strict protocols to ensure data integrity. The protocol consists of five types of

signaling on one line: Reset Sequence with Reset Pulse and Presence Pulse, Write 0, Write 1, Read Data

and Program Pulse. All these signals except Presence Pulse are initiated by the bus master. The

initialization sequence required to begin any communication with the DS1985 is shown in Figure 9. A

Reset Pulse followed by a Presence Pulse indicates the DS1985 is ready to accept a ROM command. The

and goes into receive mode (RX). The 1-Wire bus is pulled to a high state via the pullup resistor. After

Read/Write Time Slots

The definitions of write and read time slots are illustrated in Figure 10. All time slots are initiated by the

master driving the data line low. The falling edge of the data line synchronizes the DS1985 to the master

by triggering a delay circuit in the DS1985. During write time slots, the delay circuit determines when the

DS1985 will sample the data line. For a read data time slot, if a “ 0 “ is to be transmitted, the delay circuit

determines how long the DS1985 will hold the data line low overriding the 1 generated by the master. If

the data bit is a “1”, the iButton will leave the read data time slot unchanged.

PROGRAM PULSE

To copy data from the 8-bit scratchpad to the EPROM Data or Status Memory, a Program Pulse of 12

volts is applied to the data line after the bus master has confirmed that the CRC for the current byte is

correct. During programming, the bus master controls the transition from a state where the data line is

idling high via the pullup resistor to a state where the data line is actively driven to a programming

voltage of 12 volts providing a minimum of 10 mA of current to the DS1985. This programming voltage