TS5215

300mA Low Noise LDO

Voltage Regulator with Enable

3/9

Version: B07

Electrical Specification (Continue)

Note:

1. Exceeding the absolute maximum rating may damage the device.

allowable power dissipation will result in excessive die temperature, and the regulator will go into thermal shutdown.

3. The device is not guaranteed to function outside its operating rating.

4, Output voltage temperature coefficient is defined as the worst case voltage change divided by the total temperature

range.

5, Regulation is measured at constant junction temperature using low duty cycle pulse testing. Parts are tested for

in output voltage due to heating effects are covered by the thermal regulation specification.

6, Dropout voltage is defined as the input to output differential at which the output voltage drops 2% below its nominal

value measured at 1V differential.

7, Ground pin current is the regulator quiescent current plus pass transistor base current. The total current drawn from

the supply is the sum of the load current plus the ground pin current.

8, Thermal regulation is defined as the change in output voltage at a time “t” after a change in power dissipation is

applied, excluding load or line regulation effects. Specifications are for a 300mA load pulse at Vin=16V for t=10mS.

Block Diagrams