Low Power Infrared Transceiver

GP2W0001YP/GP2W0002YP

Technical Information

13

MOISTURE-PROOF PACKING

INFORMATION

Scope

Th is section de scribe s the specifications of

GP2W0001YP/GP2W0002YP moisture-proof packing,

and is only for reference. The official specifications

should be consulted for packing information.

Packing Material Specifications

The GP2W0001YP/GP2W0002YP reel is moisture-

proof packed for shipment. Table 3 describes the mate-

rials used for each item of the moisture-proof packing.

Packing Method

1. Seal the aluminum laminate bag that contains the

tape reel (2,000 devices/reel) and desiccant.

2. Fill in the necessary information on the label and

paste it on the aluminum laminate bag.

3. Pack 4 aluminum laminated bags (1 reel each) into

the designated outer case, placing paper pads on

the bottom and top of the outer case, as well as be-

tween each layer of the aluminum laminated bags.

See Table 4.

4. Seal the outer case with craft tape, indicating the

model name, quantity, and out-going inspection date

on the case. (8,000 pieces total per carton)

Storage and Treatment

STORAGE CONDITIONS

The product should be stored under these conditions:

• Storage temperature: 10°C to 30°C

• Humidity: below 60% RH

TREATMENT AFTER UNSEALING

1. After unsealing, devices should be mounted at a

temperature of 10°C to 30°C, humidity below 60%

RH, within 3 days.

2. For long term storage, devices should either be

stored in a dry box, or re-sealed in a moisture-proof

bag with desiccant and stored in an environment

where the temperature is 10°C to 30°C, humidity be-

low 60% RH. Devices must be mounted within 2

weeks.

BAKING BEFORE MOUNTING

If the devices are not kept in the storage conditions

described above, or the desiccant indicator has turned

pink, baking must be performed before devices are

mounted: baking may only be done once.

• Recommended Baking Conditions: 100°C

12 to 24 hours

NOTE: Do not bake the devices while they are still on the reel — the

reel will melt. Parts should be either temporarily mounted to

a PCB with adhesive, or placed in a metal tray. Any device

that has been out of its dry pack for more than 72 hours

should be dried in some manner prior to any automated sur-

face mount reflow process. Otherwise these devices should

be mounted and soldered by hand.

NOTE: Minimum order/shipment quantity should be one laminated bag (1 reel of 2,000 pieces).

Table 3. Packing Materials

ITEM

MATERIAL

Aluminum Laminate Bag

Aluminum Polyethylene

Label

Paper

Desiccant

Outer Case

Paper

Pads

Paper

Table 4. Packing Quantities

PACKING SHAPE

PRODUCT

QUANTITY PER REEL

QUANTITY PER BAG

Tape reel (

∅ 330 mm)

1 model

2,000 pieces

1 reel