SC1402

© 2000 SEMTECH CORP.

652 MITCHELL ROAD

NEWBURY PARK CA 91320

Multi-Output, Low-Noise Power Supply

Controller for Notebook Computers

December 15, 2000

7

PIN DESCRIPTION

Pin # Pin Name

Pin Function

1

CSH3

Current Sense Input for the 3.3V SMPS. Current limit level is 100mV referred to CSL3.

2

CSL3

Current Sense Input. Also serves as the feedback input in fixed output mode.

3

FB3

Feedback Input for the 3.3V SMPS; Connect FB3 to a resistor divider for adjustable output mode and

FB3 is regulated to REF (approx. 2.5V). FB3 selects the 3.3V fixed output voltage setting when tied to

GND.

4

12 OUT

12V, 120mA Linear Regulator Output. Input supply comes from V

minimum capacitor.

5

VDD

Supply Voltage Input for the 12 OUT Linear Regulator. Also connects to a 18V overvoltage shunt

regulator clamp.

6

SYNC

Oscillator Synchronization and Frequency Select. Tie to VL for 300kHz operation; tie to GND for

200kHz. Driven externally to SYNC between 240kHz and 350kHz.

7

TIME/ON5

Dual Purpose Timing Capacitor Pin and 5V SMPS ON/OFF Control Input. Input resistor of 1K is

required when using ON/OFF control input.

8

GND

Low noise Analog Ground and Feedback reference point.

9

REF

2.5V Reference Voltage Output. Bypass to GND with 1µF minimum capacitor.

10

PSAVE

Logic Control Input that disables PSAVE Mode when high. Connect to GND for power save mode.

11

RESET

Active Low Timed Output. RESET swings from GND to VL. Goes high after 32,000 clock cycle delay

following power up as a power good signal.

12

FB5

Feedback Input for 5V SMPS; Connect FB5 to a resistor divider for adjustable output mode and FB5

regulates to REF (approx. 2.5V). FB5 selects the 5V fixed output voltage setting when tied to GND.

13

CSL5

Current Sense Input for 5V SMPS.

14

CSH5

Current Sense Input for 5V SMPS.

15

SEQ

Input that selects SMPS power up sequence.

16

DH5

Gate Drive Output for the 5V, high side N-Channel MOSFET.

17

PHASE5

Switching Node inductor connection.

18

BST5

Boost capacitor connection for 5V, SMPS high-side gate drive. Connect a 0.1µF capacitor.

19

DL5

Gate Drive Output for the 5V, SMPS low-side N-Channel MOSFET.

20

PGND

Power Ground.

21

VL

5V, Internal Linear Regulator Output.

22

V+

Battery Voltage Input.

23

SHDN

Shutdown Control Input, active low.

24

DL3

Gate Drive Output for the 3.3V, SMPS low-side N-Channel MOSFET.

25

BST3

Boost Capacitor Connection for high side gate drive. Connect a 0.1µF capacitor.

26

PHASE3

Switching Node inductor Connection.

27

DH3

Gate Drive Output for the 3.3V, high-side N-Channel MOSFET.

28

RUN/ON3

ON/OFF Control Input of 3.3V SMPS.

Note: All logic level inputs and outputs are open collector TTL compatible.