L6229Q datasheet(18/28 Pages) STMICROELECTRONICS

номер детали	L6229Q

подробное описание детали	DMOS driver for three-phase brushless DC motor

PDF	28 Pages

Scroll/Zoom	100%

производитель	STMICROELECTRONICS [STMicroelectronics]

домашняя страница	http://www.st.com

Logo

18 / 28 page

Circuit description

L6229Q

18/28

Doc ID 15209 Rev 3

5.6

Tacho

A tachometer function consists of a monostable, with constant off time (tPULSE), whose input

is one hall effect signal (H1). It allows developing an easy speed control loop by using an

external op amp, as shown in Figure 17. For component values refer to Application

Information section.

The monostable output drives an open drain output pin (TACHO). At each rising edge of the

hall effect sensors H1, the monostable is triggered and the MOSFET connected to pin

TACHO is turned off for a constant time tPULSE (see Figure 16). The off time tPULSE can be

set using the external RC network (RPUL, CPUL) connected to the pin RCPULSE. Figure 18

gives the relation between tPULSE and CPUL, RPUL. We have approximately:

tPULSE = 0.6 · RPUL · CPUL

where CPUL should be chosen in the range 1 nF … 100 nF and RPUL in the range

20 k

Ω … 100 kΩ.

By connecting the tachometer pin to an external pull-up resistor, the output signal average

value VM is proportional to the frequency of the hall effect signal and, therefore, to the motor

speed. This realizes a simple frequency-to-voltage converter. An op amp, configured as an

integrator, filters the signal and compares it with a reference voltage VREF, which sets the

speed of the motor.

Figure 16.

Tacho operation waveforms

PULSE

------------------ V

⋅

t PULSE

VTACHO

VDD

L6229Q датащи(PDF) 18 Page - STMicroelectronics