MIC3003GML datasheet(58/75 Pages) MICREL

58 / 75 page

Micrel, Inc.

MIC3003

November 2009

M9999-111209-C

hbwhelp@micrel.com or (408) 955-1690

OEM Configuration Register 2 (OEMCFG2)

D[7]

SMBADR[3]

read/write

D[6]

SMBADR[2]

read/write

D[5]

SMBADR[1]

read/write

D[4]

SMBADR[0]

read/write

D[3]

read/write

D[2]

TRSTCLR[2]

read/write

D[1]

TRSTCLR[1]

read/write

D[0]

TRSTCLR[0]

read/write

Default value

1010 0010b = xxh (device address = 1010 xxxxb)

This value is the basis for using A0 h, A2 h, A4 h, and A6 h as the names of

the different device address spaces of the MIC3003.

Serial address

A6h

Byte address

2 = 02h

Caution: Changes to SMBADR take effect immediately. Any accesses following a write to SMBADR must be to the newly

programmed serial bus address.

A valid OEM password is required for access to this register. This register is non-volatile and will be maintained through power

and reset cycles.

Bit(s)

Function

Operation

D[7:4]

SMBADR[3:0]

Most significant four bits of the

serial bus device address

Writes take effect immediately.

D[3:0]

TRSTCLR[2:0]

Set the delay between QGPO and

the clearing of RESETOUT

These three bits set the delay between the deassertion

edge of the QGPO output in Reset mode and the

subsequent clearing of the three RESETOUT bits in the

RESETOUT Register:

000: Zero delay

001: 17.5 ms typical

010: 22.5 ms typical (default)

011: 27.0 ms typical

100: 45 ms typical

Minimum and maximum values may be found by adding

tolerances of -10% and +10% to the above values.

If Reset mode is not selected, these bits have no function.

MIC3003GML датащи(PDF) 58 Page - Micrel Semiconductor

MIC3003GML датащи(HTML) 58 Page - Micrel Semiconductor

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75

датащи скачать

ссылки URL