ZXLD1360 datasheet(13/25 Pages) DIODES

13 / 25 page

ZXLD1360

Document number: DS33471 Rev. 3 - 2

13 of 25

www.diodes.com

December 2010

A Product Line of

Diodes Incorporated

Application Information

Setting nominal average output current with external resistor RS

The nominal average output current in the LED(s) is determined by the value of the external current sense resistor (RS)

connected between VIN and ISENSE and is given by:

IOUTnom = 0.1/RS [for RS > 0.1Ω]

The table below gives values of nominal average output current for several preferred values of current setting resistor (RS) in

the typical application circuit shown on page 1:

RS (Ω)

Nominal average

output current (mA)

0.1

1000

0.13

760

0.15

667

The above values assume that the ADJ pin is floating and at a nominal voltage of VREF (=1.25V). Note that RS = 0.1V is the

minimum allowed value of sense resistor under these conditions to maintain switch current below the specified maximum

value.

It is possible to use different values of RS if the ADJ pin is driven from an external voltage. (See next section).

Output current adjustment by external DC control voltage

The ADJ pin can be driven by an external dc voltage (VADJ), as shown, to adjust the output current to a value above or below

the nominal average value defined by RS.

The nominal average output current in this case is given by:

IOUTdc = (VADJ /1.25) x (100mV/RS) [for 0.3< VADJ <2.5V]

Note that 100% brightness setting corresponds to VADJ = VREF. When driving the ADJ pin above 1.25V, RS must be

increased in proportion to prevent IOUTdc exceeding 550mA maximum.

The input impedance of the ADJ pin is 50k

Ω ±25% for voltages below VREF and 20kΩ ±25% for voltages above VREF

+100mV.

GND

ZXLD1360

ADJ

GND

ZXLD1360 датащи(PDF) 13 Page - Diodes Incorporated