ZXLD1352

ZXLD1352

Document number: DS33469 Rev. 3 - 2

13 of 21

www.diodes.com

December 2010

© Diodes Incorporated

A Product Line of

Diodes Incorporated

Output Current Adjustment by PWM Control

Directly driving ADJ input

Driving the ADJ input via open collector transistor

The recommended method of driving the ADJ pin and controlling the amplitude of the PWM waveform is to use a small NPN

switching transistor as shown below:

This scheme uses the 50k resistor between the ADJ pin and the internal voltage reference as a pull-up resistor for the external

transistor eg MMBT3904.

Driving the ADJ input from a microcontroller

Another possibility is to drive the device from the open drain output of a microcontroller. The diagram below shows one method

of doing this:

If the NMOS transistor within the microcontroller has high Gate / Drain capacitance, this arrangement can inject a negative spike

into ADJ input of the ZXLD1352 and cause erratic operation but the addition of a Schottky clamp diode (eg Diodes Inc.

SD103CWS) to ground and inclusion of a series resistor (3.3k) will prevent this. See the section on PWM dimming for more

details of the various modes of control using high frequency and low frequency PWM signals.

 

PWM

GND

0V

GND

ZXLD1352

ADJ

GND

ZXLD1352

ADJ

MCU

10k

PWM

GND

ZXLD1352

ADJ

GND