| поискавой системы для электроныых деталей |
|
CMPWR150 датащи(PDF) 12 Page - ON Semiconductor |
|
|
|||||||||||||||||||||||||||||
CMPWR150 датащи(HTML) 12 Page - ON Semiconductor |
|
12 / 15 page ![]() CMPWR150 Rev. 3 | Page 12 of 15 | www.onsemi.com Typical Thermal Characteristics Thermal dissipation of junction heat consists primarily of two paths in series. The first path is the junction to the case ( θ JC) thermal resistance, which is defined by the package style, and the second path is the case to ambient ( θ CA) thermal resistance, which is dependent on board layout. For a given package style and board layout, the operating junction temperature is a function of junction power dissipation P JUNC and the ambient temperature, resulting in the following thermal equation: TJUNC = TAMB + PJUNC (θJC ) + PJUNC (θCA) Measurements showing performance up to maximum junction temperature of 125°C were performed under light load conditions (5mA). This allows the ambient temperature to be representative of the internal junction temperature. Out Vo lt V T. eps Figure 12. Output Voltage vs. Temperature Output Voltage vs. Temperature. Figure 13 shows the regulator V OUT performance up to the maximum rated junction temperature. The overall 100°C variation in junction temperature causes an output voltage change of about 30mV, reflecting a voltage temperature coefficient of 90ppm/°C. Output Voltage (500mA) vs. Temperature. Output Voltage (500mA) vs. Temperature shows the regulator steady state performance when fully loaded (500mA) in an ambient temperature up to the rated maximum of 70°C. The output variation at maximum load is approximately 25mV across the normal temperature range. Out V R v T. eps Figure 13. Output Voltage (500mA) vs. Temperature Thresholds vs. Temperature. Figure 14 shows the regulator select/deselect threshold variation up to the maximum rated junction temperature. The overall 100°C change in junction temperature causes a 30mV variation in the select threshold voltage (regulator enable). The deselect threshold level varies about 50mV over the 100°C change in junction temperature. This results in the built-in hysteresis having minimal variation over the entire operating junction temperature range. |
|
|
ссылки URL |
| Вашему бизинису помогли Аллдатащит? [ DONATE ] |
Что такое Аллдатащит | реклама | контакт | Конфиденциальность | Ссылка на техническое описание | обмен ссыками | поиск по производителю All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |