PIC18F4580-ESLASHP datasheet(35/490 Pages) MICROCHIP

35 / 490 page

DS39637D-page 35

PIC18F2480/2580/4480/4580

3.7.1

OSCILLATOR CONTROL REGISTER

The OSCCON register (Register 3-2) controls several

aspects of the device clock’s operation, both in

full-power operation and in power-managed modes.

The System Clock Select bits, SCS<1:0>, select the

clock source. The available clock sources are the

primary clock (defined by the FOSC<3:0> Configura-

tion bits), the secondary clock (Timer1 oscillator) and

the internal oscillator block. The clock source changes

immediately after one or more of the bits is written to,

following a brief clock transition interval. The SCS bits

are cleared on all forms of Reset.

The Internal Oscillator Frequency Select bits,

IRCF<2:0>, select the frequency output of the internal

oscillator block to drive the device clock. The choices

are the INTRC source, the INTOSC source (8 MHz) or

one of the frequencies derived from the INTOSC post-

scaler (31 kHz to 4 MHz). If the internal oscillator block

is supplying the device clock, changing the states of

these bits will have an immediate change on the inter-

nal oscillator’s output. On device Resets, the default

output frequency of the internal oscillator block is set at

1MHz.

When an output frequency of 31 kHz is selected

(IRCF<2:0> = 000), users may choose which internal

oscillator acts as the source. This is done with the

INTSRC bit in the OSCTUNE register (OSCTUNE<7>).

Setting this bit selects INTOSC as a 31.25 kHz clock

source by enabling the divide-by-256 output of the

INTOSC postscaler. Clearing INTSRC selects INTRC

(nominally 31 kHz) as the clock source.

This option allows users to select the tunable and more

precise INTOSC as a clock source, while maintaining

power savings with a very low clock speed. Regardless

of the setting of INTSRC, INTRC always remains the

clock source for features such as the Watchdog Timer

and the Fail-Safe Clock Monitor.

The OSTS, IOFS and T1RUN bits indicate which clock

source is currently providing the device clock. The

OSTS bit indicates that the Oscillator Start-up Timer

(OST) has timed out and the primary clock is providing

the device clock in primary clock modes. The IOFS bit

indicates when the internal oscillator block has stabi-

lized and is providing the device clock in RC Clock

modes. The T1RUN bit (T1CON<6>) indicates when

the Timer1 oscillator is providing the device clock in

secondary clock modes. In power-managed modes,

only one of these three bits will be set at any time. If

none of these bits are set, the INTRC is providing the

clock or the internal oscillator block has just started and

is not yet stable.

The IDLEN bit determines if the device goes into Sleep

mode or one of the Idle modes when the SLEEP

instruction is executed.

The use of the flag and control bits in the OSCCON

“Power-Managed Modes”.

3.7.2

OSCILLATOR TRANSITIONS

PIC18F2480/2580/4480/4580 devices contain circuitry

to prevent clock “glitches” when switching between

clock sources. A short pause in the device clock occurs

during the clock switch. The length of this pause is the

sum of two cycles of the old clock source and three to

four cycles of the new clock source. This formula

assumes that the new clock source is stable.

Clock transitions are discussed in greater detail in

Section 4.1.2 “Entering Power-Managed Modes”.

Note 1: The Timer1 oscillator must be enabled to

select the secondary clock source. The

Timer1 oscillator is enabled by setting the

T1OSCEN bit in the Timer1 Control regis-

ter (T1CON<3>). If the Timer1 oscillator is

not enabled, then any attempt to select a

secondary clock source when executing a

SLEEP instruction will be ignored.

2: It is recommended that the Timer1

oscillator be operating and stable before

executing the SLEEP instruction, or a very

long delay may occur while the Timer1

oscillator starts.

PIC18F4580-E/P датащи(PDF) 35 Page - Microchip Technology

PIC18F4580-E/P датащи(HTML) 35 Page - Microchip Technology

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

датащи скачать

ссылки URL