PCF8564ACX9SLASHBSLASH1 datasheet(21/44 Pages) NXP

21 / 44 page

PCF8564A_1

Product data sheet

Rev. 1 — 8 October 2009

21 of 44

NXP Semiconductors

PCF8564A

Real time clock and calendar

Characteristics of the I2C-bus

The I2C-bus is for bidirectional, two-line communication between different ICs or modules.

The two lines are a Serial Data Line (SDA) and a Serial Clock Line (SCL). Both lines must

be connected to a positive supply via a pull-up resistor. Data transfer may be initiated only

when the bus is not busy.

9.1 Bit transfer

One data bit is transferred during each clock pulse. The data on the SDA line must remain

stable during the HIGH period of the clock pulse as changes in the data line at this time

will be interpreted as a control signal (see Figure 12).

9.2 START and STOP conditions

Both data and clock lines remain HIGH when the bus is not busy. A HIGH-to-LOW

transition of the data line, while the clock is HIGH, is deﬁned as the START condition (S).

A LOW-to-HIGH transition of the data line, while the clock is HIGH, is deﬁned as the STOP

condition (P), see Figure 13.

9.3 System conﬁguration

A device generating a message is a transmitter, a device receiving a message is the

receiver. The device that controls the message is the master; and the devices which are

controlled by the master are the slaves (see Figure 14).

Fig 12. Bit transfer

mbc621

data line

stable;

data valid

change

of data

allowed

SDA

SCL

Fig 13. Deﬁnition of START and STOP conditions

mbc622

SDA

SCL

STOP condition

SDA

SCL

START condition

PCF8564ACX9/B/1 датащи(PDF) 21 Page - NXP Semiconductors

PCF8564ACX9/B/1 датащи(HTML) 21 Page - NXP Semiconductors

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44

датащи скачать

ссылки URL