PCA9626B datasheet(2/47 Pages) NXP

2 / 47 page

PCA9626_2

Product data sheet

Rev. 02 — 31 August 2009

2 of 47

NXP Semiconductors

PCA9626

24-bit Fm+ I2C-bus 100 mA 40 V LED driver

Features

I 24 LED drivers. Each output programmable at:

N Off

N On

N Programmable LED brightness

N Programmable group dimming/blinking mixed with individual LED brightness

I 1 MHz Fast-mode Plus compatible I2C-bus interface with 30 mA high drive capability

on SDA output for driving high capacitive buses

I 256-step (8-bit) linear programmable brightness per LED output varying from fully off

(default) to maximum brightness using a 97 kHz PWM signal

I 256-step group brightness control allows general dimming (using a 190 Hz PWM

signal) from fully off to maximum brightness (default)

I 256-step group blinking with frequency programmable from 24 Hz to 10.73 s and

duty cycle from 0 % to 99.6 %

I 24 open-drain outputs can sink between 0 mA to 100 mA and are tolerant to a

maximum off state voltage of 40 V. No input function.

I Output state change programmable on the Acknowledge or the STOP Command to

update outputs byte-by-byte or all at the same time (default to ‘Change on STOP’).

I Active LOW Output Enable (OE) input pin allows for hardware blinking and dimming of

the LEDs

I 7 hardware address pins allow 126 PCA9626 devices to be connected to the same

I2C-bus and to be individually programmed

I 4 software programmable I2C-bus addresses (one LED Group Call address and three

LED Sub Call addresses) allow groups of devices to be addressed at the same time in

any combination (for example, one register used for ‘All Call’ so that all the PCA9626s

on the I2C-bus can be addressed at the same time and the second register used for

three different addresses so that 1

⁄

3 of all devices on the bus can be addressed at the

same time in a group). Software enable and disable for I2C-bus address.

I A Chase Byte allows execution of predeﬁned ON/OFF pattern for the 24 LED outputs

I Software Reset feature (SWRST Call) allows the device to be reset through the

I2C-bus

I 25 MHz internal oscillator requires no external components

I Internal power-on reset

I Noise ﬁlter on SDA/SCL inputs

I No glitch on power-up

I Supports hot insertion

I Low standby current

I Operating power supply voltage (VDD) range of 2.3 V to 5.5 V

I 5.5 V tolerant inputs on non-LED pins

I −40 °C to +85 °C operation

I ESD protection exceeds 2000 V HBM per JESD22-A114, 200 V MM per

JESD22-A115 and 1000 V CDM per JESD22-C101

I Latch-up testing is done to JEDEC Standard JESD78 which exceeds 100 mA

I Packages offered: LQFP48, HVQFN48

PCA9626B датащи(PDF) 2 Page - NXP Semiconductors

PCA9626B датащи(HTML) 2 Page - NXP Semiconductors

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47

датащи скачать

ссылки URL