LPC2114 datasheet(2/40 Pages) NXP

2 / 40 page

LPC2114_2124_6

Product data sheet

Rev. 06 — 10 December 2007

2 of 40

NXP Semiconductors

LPC2114/2124

Single-chip 16/32-bit microcontrollers

I 128/256 kB on-chip ﬂash program memory. 128-bit wide interface/accelerator enables

high speed 60 MHz operation.

I In-System Programming (ISP) and In-Application Programming (IAP) via on-chip

bootloader software. Flash programming takes 1 ms per 512 B line. Single sector or

full chip erase takes 400 ms.

I EmbeddedICE-RT interface enables breakpoints and watch points. Interrupt service

routines can continue to execute whilst the foreground task is debugged with the

on-chip RealMonitor software.

I Embedded Trace Macrocell (ETM) enables non-intrusive high speed real-time tracing

of instruction execution.

I Four-channel 10-bit ADC with conversion time as low as 2.44 µs.

I Two 32-bit timers (with four capture and four compare channels), PWM unit (six

outputs), Real-Time Clock (RTC) and watchdog.

I Multiple serial interfaces including two UARTs (16C550), Fast I2C-bus (400 kbit/s) and

two SPIs.

I 60 MHz maximum CPU clock available from programmable on-chip Phase-Locked

Loop with settling time of 100

µs.

I Vectored Interrupt Controller with conﬁgurable priorities and vector addresses.

I Up to forty-six 5 V tolerant general purpose I/O pins. Up to nine edge or level sensitive

external interrupt pins available.

I On-chip crystal oscillator with an operating range of 1 MHz to 30 MHz.

I Two low power modes, Idle and Power-down.

I Processor wake-up from Power-down mode via external interrupt.

I Individual enable/disable of peripheral functions for power optimization.

I Dual power supply:

N CPU operating voltage range of 1.65 V to 1.95 V (1.8 V ± 0.15 V).

N I/O power supply range of 3.0 V to 3.6 V (3.3 V ± 10 %) with 5 V tolerant I/O pads.

16/32-bit ARM7TDMI-S processor.

Ordering information

Table 1.

Ordering information

Type number

Package

Name

Description

Version

LPC2114FBD64

LQFP64