AD8022ARMZ datasheet(23/75 Pages) AD

23 / 75 page

ADSP-BF506F EZ-KIT Lite Evaluation System Manual

1-3

Using ADSP-BF506F EZ-KIT Lite

Default Configuration

The ADSP-BF506F EZ-KIT Lite board is designed to run outside your

personal computer as a stand-alone unit. You do not have to open your

computer case.

When removing the EZ-KIT Lite board from the package, handle the

board carefully to avoid the discharge of static electricity, which can dam-

age some components. Figure 1-1 shows the default jumper settings,

switches, connector locations, and LEDs used in installation. Confirm

that your board is in the default configuration before using the board.

EZ-KIT Lite Installation

For correct operation, install the software and hardware in the order pre-

sented in the VisualDSP++ Installation Quick Reference Card. Substitute

instructions in step 3 with instructions in this section.

There are two options to connect the EZ-KIT Lite hardware to a personal

computer (PC) running VisualDSP++ 5.0: via an Analog Devices emula-

tor or va a standalone debug module. The standalone debug agent allows a

debug agent to interface to the ADSP-BF506F EZ-KIT Lite. The standal-

one debug agent is shipped with the kit.

The EZ-KIT Lite evaluation system contains ESD (electrostatic discharge)

sensitive devices. Electrostatic charges readily accumulate on the human body

and equipment and can discharge without detection. Permanent damage may

occur on devices subjected to high-energy discharges. Proper ESD precautions

are recommended to avoid performance degradation or loss of functionality.

Store unused EZ-KIT Lite boards in the protective shipping package.

AD8022ARMZ датащи(PDF) 23 Page - Analog Devices