AM1707 datasheet(64/198 Pages) TI

64 / 198 page

AM1707

SPRS637A – FEBRUARY 2010 – REVISED APRIL 2010

www.ti.com

6.11 External Memory Interface A (EMIFA)

EMIFA is one of two external memory interfaces supported on the device . It is primarily intended to

support asynchronous memory types, such as NAND and NOR flash and Asynchronous SRAM. However

the EMIFA also provides a secondary interface to SDRAM.

6.11.1 EMIFA Asynchronous Memory Support

EMIFA supports asynchronous:

•

SRAM memories

•

NAND Flash memories

•

NOR Flash memories

The EMIFA data bus width is up to 16-bits on the ZKB package . The device supports up to fifteen

address lines and an external wait/interrupt input. Up to four asynchronous chip selects are supported by

EMIFA (EMA_CS[5:2]) .

All four chip selects are available on the ZKB package.

Each chip select has the following individually programmable attributes:

•

Data Bus Width

•

Read cycle timings: setup, hold, strobe

•

Write cycle timings: setup, hold, strobe

•

Bus turn around time

•

Extended Wait Option With Programmable Timeout

•

Select Strobe Option

•

NAND flash controller supports 1-bit and 4-bit ECC calculation on blocks of 512 bytes.

6.11.2 EMIFA Synchronous DRAM Memory Support

The device ZKB package supports 16-bit SDRAM in addition to the asynchronous memories listed in

Section 6.11.1. It has a single SDRAM chip select (EMA_CS[0]). SDRAM configurations that are

supported are:

•

One, Two, and Four Bank SDRAM devices

•

Devices with Eight, Nine, Ten, and Eleven Column Address

•

CAS Latency of two or three clock cycles

•

Sixteen Bit Data Bus Width

•

3.3V LVCMOS Interface

Additionally, the SDRAM interface of EMIFA supports placing the SDRAM in Self Refresh and Powerdown

Modes. Self Refresh mode allows the SDRAM to be put into a low power state while still retaining memory

contents. Powerdown mode achieves even lower power, except the processor must periodically wake the

SDRAM up and issue refreshes if data retention is required.

Finally, note that the EMIFA does not support Mobile SDRAM devices. Table 6-18 below shows the

supported SDRAM configurations for EMIFA.

Peripheral Information and Electrical Specifications

Submit Documentation Feedback

Product Folder Link(s): AM1707

AM1707 датащи(PDF) 64 Page - Texas Instruments

AM1707 датащи(HTML) 64 Page - Texas Instruments

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

датащи скачать

ссылки URL