ATmega162 datasheet(115/324 Pages) ATMEL

115 / 324 page

115

2513K–AVR–07/09

ATmega162/V

ing a logical one to its I/O bit location. The Waveform Generator uses the match signal to

generate an output according to operating mode set by the Waveform Generation mode

(WGMn3:0) bits and Compare Output mode (COMnx1:0) bits. The TOP and BOTTOM signals

are used by the Waveform Generator for handling the special cases of the extreme values in

some modes of operation (See “Modes of Operation” on page 118.)

A special feature of output compare unit A allows it to define the Timer/Counter TOP value (i.e.,

counter resolution). In addition to the counter resolution, the TOP value defines the period time

for waveforms generated by the Waveform Generator.

Figure 49 shows a block diagram of the output compare unit. The small “n” in the register and bit

names indicates the device number (n = n for Timer/Counter n), and the “x” indicates output

compare unit (A/B). The elements of the block diagram that are not directly a part of the output

compare unit are gray shaded.

Figure 49. Output Compare Unit, Block Diagram

The OCRnx Register is double buffered when using any of the twelve Pulse Width Modulation

(PWM) modes. For the normal and Clear Timer on Compare (CTC) modes of operation, the dou-

ble buffering is disabled. The double buffering synchronizes the update of the OCRnx Compare

occurrence of odd-length, non-symmetrical PWM pulses, thereby making the output glitch-free.

The OCRnx Register access may seem complex, but this is not case. When the double buffering

is enabled, the CPU has access to the OCRnx Buffer Register, and if double buffering is dis-

abled the CPU will access the OCRnx directly. The content of the OCR1x (Buffer or Compare)

automatically as the TCNT1 and ICR1 Register). Therefore OCR1x is not read via the high byte

temporary register (TEMP). However, it is a good practice to read the low byte first as when

accessing other 16-bit registers. Writing the OCRnx Registers must be done via the TEMP Reg-

ister since the compare of all 16 bits is done continuously. The high byte (OCRnxH) has to be

written first. When the high byte I/O location is written by the CPU, the TEMP Register will be

OCFnx (Int.Req.)

= (16-bit Comparator )

OCRnx Buffer (16-bit Register)

OCRnxH Buf. (8-bit)

OCnx

TEMP (8-bit)

DATA BUS (8-bit)

OCRnxL Buf. (8-bit)

TCNTn (16-bit Counter)

TCNTnH (8-bit)

TCNTnL (8-bit)

COMnx1:0

WGMn3:0

OCRnx (16-bit Register)

OCRnxH (8-bit)

OCRnxL (8-bit)

Waveform Generator

TOP

BOTTOM

ATmega162 датащи(PDF) 115 Page - ATMEL Corporation

ATmega162 датащи(HTML) 115 Page - ATMEL Corporation

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

датащи скачать

ссылки URL