ATmega16 datasheet(268/357 Pages) ATMEL

268 / 357 page

268

2466S–AVR–05/09

ATmega16(L)

Programming the

EEPROM

The EEPROM is organized in pages, see Table 108 on page 262. When programming the

EEPROM, the program data is latched into a page buffer. This allows one page of data to be

programmed simultaneously. The programming algorithm for the EEPROM data memory is as

follows (refer to “Programming the Flash” on page 265 for details on Command, Address and

Data loading):

A: Load Command “0001 0001”.

G: Load Address High Byte ($00 - $FF)

B: Load Address Low Byte ($00 - $FF)

C: Load Data ($00 - $FF)

E: Latch data (give PAGEL a positive pulse)

K: Repeat 3 through 5 until the entire buffer is filled

L: Program EEPROM page

Set BS1 to “0”.

Give WR a negative pulse. This starts programming of the EEPROM page. RDY/BSY

goes low.

Wait until to RDY/BSY goes high before programming the next page. (See Figure 130 for

signal waveforms)

Figure 130. Programming the EEPROM Waveforms

Reading the Flash

The algorithm for reading the Flash memory is as follows (refer to “Programming the Flash” on

page 265 for details on Command and Address loading):

A: Load Command “0000 0010”.

G: Load Address High Byte ($00 - $FF)

B: Load Address Low Byte ($00 - $FF)

Set OE to “0”, and BS1 to “0”. The Flash word Low byte can now be read at DATA.

Set BS1 to “1”. The Flash word High byte can now be read at DATA.

RDY/BSY

RESET +12V

PAGEL

BS2

0x11

ADDR. HIGH

DATA

ADDR. LOW

DATA

ADDR. LOW

DATA

XA1

XA0

BS1

XTAL1

ATmega16 датащи(PDF) 268 Page - ATMEL Corporation

ATmega16 датащи(HTML) 268 Page - ATMEL Corporation

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

датащи скачать

ссылки URL